SENTRY GUARDING SYSTEM 600 GUARDING Manuals

GUARDING SYSTEM INSTALLATION MANUAL 600, 900, 1200 Guarding Patented Design AS/NZS 4024.3610 STRENGTH TESTED EASY INSTALLATION MODULAR SYSTEM COST SAVING UP TO 30% A PRODUCT OF Safety & General Information This Installation Manual is provided as an assembly guide for the Sentry Guarding System. Refer to the Design Guide for recommended layouts for various job site conditions. The product may be unstable during installation until fully assembled. Proper safety measures must be taken at all times. Product may fail and void warranty if installation does not comply with standards, design guide and drawings. Sentry Guarding System has been designed and tested to comply with: AS/NZS 4024.3610 - Safety of Machinery - Conveyors. Tools • 17mm ring spanner • Riveter Blindnut Kit (M10) • Rivet Gun • 6mm Hex Key Personal Protective Equipment • Safety Glasses • Protective Gloves • Safety Footware Equipment Required: Step 1 Install M10 Rivet nut using Blindnut Riveter. Step 2 Tighten mild steel shoulder bolt M10 x 12 x 50LG / Stainless Steel shoulder bolt (Part No: SGS10-12-50SS) to 44.7Nm using hex key. Note: Mild Steel shoulder bolt should be hot dip galvanised in place with post. Post Assembly Guarding Assembly Post Configurations: 90° layout 180° layout T - layout Single layout B A Step 1 Engage all bracket hooks onto wire mesh B and swing bracket to align with the side of the mesh panel. Step 3 Secure mesh locking tabs using 6.4 stainless steel rivets (Ø4.8mm, 6.4mm grip). Step 4 Slide top tab of latch assembly between wire mesh and bracket. Locate front washer on front face and secure with 6.4 stainless steel rivets. Step 5 Screw M10 bolt with spring washer, half way into latch assembly. Step 2 Insert all four mesh locking tabs into allocated slots.