PureLink PT-E-HD50 Operation & User’s Manual

Model PT-E-HD50 Designed in Germany © 2016 PureLink GmbH All rights reserved. Revision date 2016-03-17 Version 2 ...

1.1 Safety and Notice Please read all of these instructions carefully before you use the device. Save this manual for future reference. The PT-E-HD50 HDMI over Single Cat.X Extender with HDBaseT, RS232, Bi-directional IR, Ethernet & POC is compliant to safety regulations and requirements and has been certifi ...

These bonus features allow users to boost their IR control distance for remote controls up to 100m (330ft) and make IR control possible through only one single Cat.5 / 5e / 6 cable, including the A/V signal. In addition, ...

PT-E-HD50 front panel, transmitter (Tx) RJ45: Plug in a Cat-5/5e/6 cable that needs to be linked to the transmitting unit RX LED: TX /RX link indicator 2x Ethernet ports Connect to network devices (bi-directional) to forward the signal DIP Switches PIN#1: Setup the RS-232 mode for serial communication channel PIN ...

RJ45: Plug in a Cat.5 / 5e / 6 cable and link it to the transmitting unit LED: TX /RX link indicator 2x Ethernet ports: Connect to network devices (bi-directional) to forward the signal DIP Switches: PIN#1: Setup the RS-232 mode for serial communication channel PIN#2: For firmware updates RS-232: Co ...

IR Extenders IR Blaster IR Receiver IR Sockets IR Blaster: Plug in the IR blaster to emit all IR command signals received from the IR receiver from the other end to control the devices corresponding to the IR signals. IR Receiver: Plug in the IR receiver to receive all IR command signals from the IR remote controls o ...

Type A (Receptacle) HDMI Pin 1 TMDS Data2+ Pin 11 TMDS Clock Shield Pin 2 TMDS Data2 Shield Pin 12 TMDS Clock– Pin 3 TMDS Data2– Pin 13 NC Pin 4 TMDS Data1+ Pin 14 Reserved (N.C. on device) Pin 5 TMDS Data1 Shield Pin 15 SCL Pin 6 TMDS Data1– Pin 16 SDA Pin 7 TMDS Data0+ Pin 17 DDC/CEC Ground Pin 8 TMDS Dat ...

1. Introduction What is HDBaseT Manager? HDBaseT Manager is a specialized software, focusing on detecting the connection environment and providing on-site testing possibilities to find potential problems efficiently and easily. How does HDBaseT Manager help? HDBaseT Manager offers service in 4 parts • Firmware: Qu ...

The upper part reveals the IC type / firmware version on the TX and RX units. 2.2 Update the required firmware In the lower parts you will see the information as shown 2.3 Whenever you want to update the firmware, follow these steps: Step Action 1 Select local (TX) or remote (RX) device for firmwar ...

Note: The setting will affect the status page and burn-in test function to work 3.1 Push „Start“ in the corner to get the connction‘s information 4. Check the connection status 4.1 In the upper part, it will show the mode and source type 4.2 If connected successfully, you will see this as below: Normal 10 ...