Tanaka THB-2510 Owner's Manual

Bedienungsanleitung Manual del propietario Instruktionsbok (En, Fr, It, Ge, Sp, Sw) THB-2510 / N TBL-4600 / 4610 TBL-505 970-41317-214 2004. 07 ...

chemicals known to the State of California to cause cancer, birth defects and other reproductive harm. It is important that you read, fully understand and observe the following safety precautions and warnings. Careless or improper use of the unit may cause serious or fatal injury. Il est essentiel de lire et de c ...

vacuum pipe and bag must be in place. For blower, dust cover must be securely installed. AVERTISSEMENT Ne pas toucher la turbine en rotation avec la main. Le tube d'aspiration et le sac doivent être en place avnt utilisation en aspirateur. Le carter contre la poussière doit être fixé solidemment. AVVERTIME ...

Warnings and safety instructions Assembly procedures Operating procedures Maintenance Specifications En 1 3 9 11 17 26 Index Read the operator's manual carefully. Check that the blower is correctly assembled and adjusted. Start the unit and check the carburetor adjustment. See "Maintenance". Before using your new unit ¿Qué es qué? Adverte ...

Since this manual covers several models, there may be some difference between pictures and your unit. Use the instructions that apply to your unit. 1. Fuel cap 2. Throttle trigger 3. Starter handle 4. Fuel tank 5. Carburetor 6. Air cleaner 7. Handle 8. Suspension eyelet 9. Ignition switch 10. Straight pi ...

worn during operation. Always wear a safety face shield or goggles. Always wear heavy, long pants, boots and gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair so it is above shoulder length. Do not operate that tool when you are tired, ill or under the influence of alcohol, d ...

clamp (1). Finger-tighten the clamp. Connect swivel pipe (4) to flexible pipe with clamp (3). Install throttle grip (5) to swivel pipe so that the grip locates 2-3 cm away from projection (6) on swivel pipe. Finally, if direction of bent pipe does not match the direction of throttle grip, loosen knob (7) or wing bo ...

10 Das biegsame Rohr (2) mit einer Drahtklammer (1) am Gehäuse befestigen. Das Schwenkrohr (4) mit einer Drahtklammer (3) am biegsamen Rohr befestigen. -Den Gasgriff (5) so an das Schwenkrohr montieren, dass der Griff etwa 2-3 cm von dem Vorsprung (6) am Schwenkrohr entfernt ist. Abschließend, falls die Ausric ...

gasoline. Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of 25-50 : 1 (Gasoline (A) : Oil (B)), only for the state of California at 50:1. Never use multi-grade oil (10 W/30) or waste oil. Always mix fuel and oil in a separate clean container. I t Always start by filling half the amount of fuel, which ...

ground or any other object. 1. Set ignition switch (1) to ON position. (Fig. 2-2, 2B, 2C) * Push priming bulb (4) several times so that fuel flows through return pipe (5) (If so equipped) (Fig. 2-3, 3B) * Move throttle lever to a half-open position (2) and lock ...