Sun Microsystems 6500 Installation Manual

3-7 Note – When the system finishes booting for the first time — if there is no appropriate server configuration file on the disk drive — it may be necessary to prevent the JumpStart automatic configuration program from running. See the caution in Section 3.1 “Using JumpStart Automatic Installation.” 3.2.3 I ...

Sun Microsystems 6500 1-5 1.2 Preparing the Electrical Circuits In planning where to place your equipment, remember that each of the following items requires access (by way of a separate power cord) to a power outlet: I Sun Enterprise 6500/5500/4500 system I External peripherals I Monitor used for diagnostics 1.2.1 Enterprise 6500/5500 Cabinet ...

Sun Microsystems 6500 Statements Your Sun product is marked to indicate its compliance class: I Federal Communications Commission (FCC)—U.S.A. I Department of Communications (DOC)—Canada I Voluntary Control Council for Interference (VCCI)—Japan I European Union (CE mark)—Europe I Bureau of Standards Metrology and Inspection (BSM ...

Sun Microsystems 6500 3-9 3.3 Enterprise 4500 System 3.3.1 Powering On the System Note – It is advisable to connect an ASCII terminal to the system during installation. See Section 2.6 “Connecting an ASCII Terminal,” for terminal settings and connections. Observe the yellow (middle) LED on the front panel. It should go off when the b ...

Sun Microsystems 6500 1-3 3. Remove inner packing materials from the top and corners of the cabinet. 4. At the front of the pallet, lift the Velcro™strip at each end of the wooden bar to detach the bar, then set it aside. 5. Slide out the two wooden ramps from under the cabinet. 6. Attach the wooden ramps to the pallet using the Velcro strip ...

3. Turn the system key switch to (the Standby position) (FIGURE 2-1). FIGURE 2-1 Key Switch Standby Position 4. Ensure that the AC power sequencer switch (FIGURE 2-2) is set to Off. FIGURE 2-2 AC Power Sequencer Power Switch 5. Open the back door and take out the AC power cord that ...

FIGURE 3-5 Key Switch on the Enterprise 4500 4. Turn the AC power switch (FIGURE 3-6) to On. 5. Turn the key switch (FIGURE 3-5) to the On position. You should see and hear several things happen: I The fans in the power supplies begin turning. I The top front panel LED (green) turn ...

Sun Microsystems 6500 FIGURE 1-7 Moving the Server Safely Down the Ramps 1.6.2 Adjusting the Levelling Pads After moving the cabinet to its operating location, adjust the levelling pads. 1. Remove the levelling wrench from inside the server cabinet. The levelling wrench is attached to the cabinet frame ...

Sun Microsystems 6500 Declaration of Conformity Compliance ID: 1610/1601 Product Name: Sun Enterprise 6500 Family EMC European Union This equipment complies with the following requirements of the EMC Directive 89/336/EEC: Safety This equipment complies with the following requirements of the Low Voltage D ...

Sun Microsystems 6500 The attachment-plug receptacles in the vicinity of the unit or system are all to be of an earthing type, and the earthing conductors serving these receptacles are to be connected to earth at the service equipment.1 The power cord provides a ground path that will protect the drives a ...

Sun Microsystems 6500 2.2 Removing and Replacing the Enterprise 6500/5500 Cabinet Rear Door and Kick Panel 2-1 2.2.1 Removing the Rear Door and Kick Panel 2-1 2.2.2 Replacing the Rear Door and Kick Panel 2-3 2.3 Connecting the Power Cords 2-3 2.3.1 Enterprise 6500/5500 System Power Cord 2-3 2.3.2 Enterpri ...