TRENDnet TEG-160WS Quick Installation Manual

English ...................................................................................................... Troubleshooting ........................................................................................ 1 1 3 2 6 1. Before You Start 2. Hardware Installation ................................................................... ...

� Utility & User Guide CD-ROM � 2 Mounting Brackets with Screws � Power Cord � Web Browser: Internet Explorer (5.0 or above), Netscape (6.0 or above) � Computer with Network adapter installed � Optional Mini-GBIC modules (e.g. TEG-MGBSX, TEG-MGBS10, TEG-MGBS40, ...

English 2 2. Connect a CAT-5e or 6 RJ-45 network cable from the computer to an available Ethernet port of the TEG-160WS/TEG-240WS. 1. Connect the Power Cord to the rear of the TEG-160WS/ TEG-240WS and then to a power outlet. Note: 1. After hardware installation is complete, use the Web Browser to configure the TEG-160WS/TEG-240WS. ...

the network, assign IP Address, change the password, and upgrade to new firmware, then install the Web Management Utility. Follow the steps below. 3. Click Start > Programs > web_management_utility, and then click web_management_utility. 3. Web Management Utility For W ...

click the Switch that appears in the Discovery List. 5. Click the Switch in the Monitor List and then click Configuration setting. 6. Configure the IP Address, Subnet mask, Gateway, and Password. Click Set. ...

8. Click Access Web. 9. Type in your Password and then click Login. By default, the Password is admin. For more information regarding the Web-based Smart Utility configuration and advanced settings, please refer to the User's Guide included on the Utility & Driver CD-ROM or TRENDnet's website at www.trendnet.com Register Your Product ...

on. Check the connection of the power cord to the TEG-160WS/TEG-240WS and the power outlet. Also check that the power outlet is receiving power. After installing the Web-Management Utility, I clicked Discovery and the Utility is unable to ...

Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY R ...

Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com/register 20675 Manhattan Place Torrance, CA 90501 USA ...