THOMSON EFC031E Technical Information

Alimentación Circuito de deflexión_H Circuito de deflexión_V Circuito RF-FI TRC - Pantalla Conectores - Scart Mecánica Panel de control Tratamiento de datos Tratamiento de audio Sección : Tratamiento de video General ...

EFC031E 1.1 TV set ON. 1.2 While keeping pressed the ”VOL-” key on the TV keyboard press ”EXIT” on the RC until TV set switch on and enter service mode. (Main menu). IFC130 - EFC031E (according software version) 1.1 Switch the TV set into the Standby Mode. 1.2 While keeping pressed the ”VOL-” key on the TV keyboard pr ...

2 First issue 02 / 06 6 - DISPLAYING THE VALUE OF THE SETTING VIDEO 7 - TOGGLE FUNCTION To enable a function check (tick) the box. : Implemented function : No implemented function (Brightness -0003 Affichage ➠ + > NVM valeur Affichage ➠ - < NVM valeur Valeur décimale Valeur de réglage : NVM valeur > ...

First issue 02 / 06 3 ( Factory setting EFC031_X181-0 Return Sound Miscellaneous Video Field Service ... ... ... ... ... Alignment Alignement Ableigh Regolazione Alineacion Software version Version Software Software Version Versione softaware Versión software SUBMENU ...

4 First issue 02 / 06 II - EFC031E CHASSIS - ALIGNMENT 1 VIDEO 1.1 Conditions - The TV set should be warmed up for 60 minutes. - The following conditions are automatically set when entering the Video submenu. * Set these conditions in the User menu 1.2 Y, Pb, Pr Component Input Video test pattern 1.3 VGA Input Standard Monitor Format (VES ...

First issue 02 / 06 5 1.4 Video Calibration EFC031E 1.4.1 MST9883 ADC Calibration YPbPr Calibration for TV display format - Connect Y, Pb, Pr signal to BV280 connector (”Video Components Enter”) with the following standard. Input signal parameters: - Exit temporary from Service Mode and select the ”Video Components Enter” (press t ...

6 First issue 02 / 06 1.4.2 RGB RGB Calibration for Standard monitor format (VESA) - Connect R, G, B Hsync and Vsync with following standard into VGA BV300 connector: - Exit temporary from Service Mode and select the VGA enter (press the magenta key on the RCU ”Text” to come back at the service mode) - Video pattern to calibrate - Se ...

First issue 02 / 06 7 2.1 Cut Off Cutt Off alignment has to be done for the following standards : Note: After Cut Off alignment control white point alignment. Repeat the adjustments if necessary. R offset G Offset B Offset +0007 +0024 +0016 - Insert a grey test pattern giving 15 Nits luminance level - Measure the color co-ordinates near the ...

8 First issue 02 / 06 2.4 Scaling Colour - Scaling Color Alignment has to be done for the following standards : - 75% Color bar test pattern. - Measure the Blue output and adjust Colour to equal levels as shown bellow: 2.5 Scale Tint - No alignment for EU models. 2.6 Peak White Alignment - Peak White test pattern (100%).Colourimeter. - Peak ...

First issue 02 / 06 9 3 - SOUND - The items of the SOUND menu are not used 4 - MISCELLANEOUS - EFC031E 4.1 Reset the values to ROM default - Reset all the EEPROM data to FF. Only required if the EEPROM data are corrupted. After ”reset the values to ROM default” the alignment, calibration and channel installation is necessary. 4.2 LUMA_TE ...