SHOWTEC XS-2 Dual Beam Manual 

Highlite International B.V. – Vestastraat 2 – 6468 EX – Kerkrade – the Netherlands Ordercode: 40173 MANUAL ENGLISH ...

Table of contents Warning .................................................................................................................................................................................................... 2 Unpacking Instructions .............................................................................. ...

Warning Unpacking Instructions Immediately upon receiving this product, carefully unpack the carton and check the contents to ensure that all parts are present, and have been received in good condition. Notify the dealer immediately and retain packing material for inspection if any parts appear damaged from shipping or the c ...

Before the initial start-up, please make sure that there is no damage caused by transportation. Should there be any, consult your dealer and do not use the device. To maintain perfect condition and to ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes containe ...

• The user is responsible for correct positioning and operating of the XS-2 Dual Beam. The manufacturer will not accept liability for damages caused by the misuse or incorrect installation of this device. • This device falls under protection class I. Therefore it is essential to connect the yellow/green conductor to eart ...

Connection with the mains Connect the device to the mains with the power plug. Always check if the right color cable is connected to the right place. International EU Cable UK Cable US Cable Pin L BROWN RED YELLOW/COPPER PHASE N BLUE BLACK SILVER NEUTRAL YELLOW/GREEN GREEN GREEN PROTECTIVE GROUND Make sure that the device is ...

Description of the device Features The XS-2 Dual Beam consists of two compact 10W LED moving heads, attached to a T-bar. The fixture creates two strong and tight beams. The XS-2 Dual Beam is the ideal solution for mobile DJs and will create a fantastic lightshow with only one unit. Combine the XS-2 Dual Beam with a Showtec c ...

Backside Fig. 02 03) Adjustment screw 04) 3-pin DMX signal connector IN 05) 3-pin DMX signal connector OUT 06) IEC Power connector 100-240V (OUT) 07) IEC Power connector 100-240V (IN) 08) Fuse F3AL/250V 09) Safety eye 10) T-bar, attach the Dual Beam to a truss, using the included M10 screws and the mounting bracket. Installa ...

Control Modes There are 4 modes: • Stand-alone (built-in programs) • Sound-controlled mode • Master/Slave mode • DMX512 (10, 17 or 20 channels) One XS-2 Dual Beam (Built-in Programs) 01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation. 02) Plug the end of the elec ...

Multiple Dual Beams (DMX Control) 01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation. 02) Always use a safety cable (ordercode 70140 / 70141). 03) Plug the end of the electric mains power cord into a proper electric power supply socket. 04) Use a 3-pin XLR cable to conne ...