BigPlanes Pzl-104 Wilga-80 Instruction Manual

TP Screw (2.3x8mm) TP Screw (3x10mm) Screw (3x20mm) Screw (4x55mm) Screw (4x20mm) Screw (4x70mm) Screw (4x45mm) Screw (2x10mm) Screw (3x16mm) 4 4 8 4 Collar (3mm) 1 6 1 4 2 4 4 Collar (4mm) 1 8 8 4 Nut(2mm ) Nut(3mm ) Lock Nut(4mm ) 8 Washer(2x6mm) Washer(3x6mm) Washer(4x8mm) 8 2 6 1 1 1 22 2 2 4 1 2 1 3 10 10 2 2 1 2 4 1 4 Blind Nut ...

15"X7 Spinner nut 6 (with 8 servos), 6 6 6 channel radio for aiplane is highly recommended for this model. Warning Remove the covering with proper pressure to cut through only the covering itself.Otherwise, cutting down into the balsa structure may weaken the model part and cause accident. The pre-covered film on ARF kits may wrinkle due to va ...

BigPlanes Pzl-104 Wilga-80 1 ...

BigPlanes Pzl-104 Wilga-80 Link the wires of the elevator to the servo,assemble the elevator servo to appropriate position in the fuselage. Fix the side of the stab strut which have a drilled hole to the pointed position on the stab, according to the hole in the tail fuselage,mark in the other side of the stab and drill hole in it and ...

BigPlanes Pzl-104 Wilga-80 Apply instant type AB glue to appropriate position of the rudder and pivot & round hinges. Insert the pivot & round hinges to the rudder. Fix the wing to fuselage with screws throught the holes applied in the wings and fuselage. Keep about 1mm width space between the tail fin ...

BigPlanes Pzl-104 Wilga-80 Wing area: 63.6sq.dm (6.9sq.ft) Wing loading: 101g/sq.dm(33oz/sq.ft) Flying weight: 6.4kg(14.08lbs) Radio: 6ch & 8servos Engine: 26cc-36cc SAFETY PRECAUTIONS INSTRUCTION MANUAL First-time builders should seek advice from ...

BigPlanes Pzl-104 Wilga-80 lose control of your airplane which leads to accidents! 8 2 2 Rod (2.5x300mm) TP Screw (2.3x12mm) Servo tray(70x58x2mm) Pivot&round hinge(4.5X67mm) 6 6 Pivot&round hinge(4.5x67mm) Install the aileron servo to the servo mount as illustration below. Install the control horn and connect the linkage. ...

BigPlanes Pzl-104 Wilga-80 pivot & round hinges. Insert the pivot & round hinges to the elevator. Trailing edge Keep some space about 1mm width between trailing edge and elevator. Epoxy the elevator to the stabilizer. Elevat ...