Milesight Network Camera v3.2 Quick Start Manual

Table of Contents 1. Package contents ............................................................................................................... 2 2. Cautions ......................................................................................................... ...

Thank you for purchasing Milesight IP camera. This Guide provides basic instructions on installing and accessing Milesight network camera. For more details, please refer to the User Manual. 1. Package contents Before installation, please verify that all the necessary ite ...

4. Hardware Overview 4.1 Box Camera Figure 4-1 *Note: 1) Error LED: Error LED is on when the device starts up or runs error. 2) Reset Button: Press ‘Reset’ button for 5 seconds, the device will be restored to factory default. *Error LED Power LED *Reset Button Ethern ...

4.2 IR Bullet Camera Figure 4-2 Power Connector (DC 12V) Alarm Input/ Output RS-485 PTZ control Ethernet Port Lens Video Output Light Sensor IR LED Audio Input Audio Output ...

4.3 Dome Camera Figure 4-3 Video Output Power Connector (DC 12V) Audio Output Audio Input RS-485 PTZ control Alarm Input/ Output Ethernet Port ...

4.4 Mini Dome Camera Figure 4-4 5. Hardware Installation 5.1GeneralConnection 1. Connect the camera to the network and power using one of the methods listed below: 1) Basic connection (without PoE): Step 1: connect the DC 12V end of the power adapter to the power port o ...

Figure 5-1 2) Power over Ethernet (PoE) connection. PoE will be automatically detected when the Ethernet cable is connected. The camera can either be connected to a PoE-enabled switch or a non-PoE switch. A. Connect the camera to a PoE switch using a single Ethernet cab ...

B. Connect the camera to a non-PoE switch using the PoE injector Step 1: Connect the camera to a PoE injector using an Ethernet cable. Step 2: Connect the PoE injector to the non-PoE switch using an Ethernet cable. Step 3: Connect the PoE injector to a power outlet. Figu ...

5.2Insert the SD card Steps: 1. Locate the SD card slot. 2. Insert the SD card into the slot with the metal contacts facing down. A. Box camera Figure 5-4 B. Vari-focal lens bullet camera Figure 5-5 Note:Vari-focal lens bullet camera is using TF card. 1 2 3 4 1 3 4 2 ...