Laser Technology TruPulse 200 Operation & User’s Manual

Page 39 Section 11 - LTI Limited Warranty What is Covered? Laser Technology, Inc. (LTI) warrants this product to be in good working order. Should the product fail to be in good working order at any time during the warranty period, LTI will, at its option, repair or replace this product at no additional charge. Parts and pr ...

Laser Technology TruPulse 200 Page 19 5. Press to store the first inclination measurement. The message “CAL_2” appears in the Main Display. 6. Rotate the TruPulse 180 degrees as shown in Figure #15B above. 7. Press to store the second inclination measurement and complete the zero offset correction. The message “donE” appears in the Main Display. 8 ...

Page 28 Optional Remote Trigger It is possible to remotely trigger the TruPulse and take a measurement by using an external computer, data collector, or switch closure. Remote triggering is accomplished by providing an open collector closure to ground or an active low TTL or RS232 level signal to ...

Laser Technology TruPulse 200 Page 42 Message Explanation Page # Shot 1 Missing Line Routine 23 Shot 2 Missing Line Routine 23 Standard target mode. 25 Units. 15 ...

Page 14 Section 4 - System Setup Modes Figure #11 shows an overview of the System Setup Mode which can be accessed from the Measurement Mode. Each option is described separately in the following sections. 1. From the Measurement Mode, press and hold for 4 seconds. “UnitS” will appear in the M ...

Laser Technology TruPulse 200 Page 20 Slope Distance (SD) Inclination (INC) Horizontal Distance (HD) Vertical Distance (VD) Section 5 - Measurement Modes When you power ON the TruPulse, the last used Measurement Mode will be active. Press or to display the previous or next Measurement Mode. Figure #16 ...

Laser Technology TruPulse 200 Page 6 Section 2 - Quick Start Note: Only International lasers include meters. 1. Install the batteries (page 7). 2. Press to power ON the TruPulse. 3. Select a target such as a tree or a building. For this example, the target should be approximately 250 feet (82 yards or 75 meters) from you. 4. ...

Laser Technology TruPulse 200 Page 34 Upload Serial Data Commands  START_MEASUREMENT: GO = Single shot (will output “E01” if no target found after 15 seconds)  STOP_MEASUREMENT: ST  SET_DISTANCE_UNITS: MU Meters: 0 Yards: 1 Feet: 2 Note: Only International lasers include meters.  SET_MEASUREMENT_MODE: MM Horizo ...

Laser Technology TruPulse 200 Page 25 Section 6 - Target Modes The TruPulse has five Target Modes which allow you to select or eliminate targets and to take the most accurate measurements possible in various field conditions. 1. From the Measurement Mode, press for 4 seconds. The active Target Mode appears in the Main Display. 2. Press or to display the previo ...

Laser Technology TruPulse 200 Page 7 Section 3 - Basic Operations Batteries Installation You may use two AA batteries (or 1 CRV3 battery) to power the TruPulse. The CRV3 battery provides approximately twice the usage time of the AA batteries. 1. Remove the battery compartment cover by gently pressing and sliding the cover in and down as shown in Figure #4A. 2 ...

Laser Technology TruPulse 200 Page 10  Target Modes CONT The unit continuously acquires targets and displays measurements while is held down. The distance to the most recently acquired target is displayed. CLOSEST The unit logs multiple targets while is held down. Of the targets acquired, the distance to the closest tar ...