Nice HSRE12 Installation Instructions Manual

IT - Istruzioni per l’installazione FR - Instructions pour l’installation ES - Instrucciones para la instalación DE - Anleitungen für die Installation PL - Instrukcje montaż NL - instructies voor de installatie Nice HSRE12 Home security radio receiver 0682 ...

Original instructions ENGLISH SPECIAL WARNINGS • For personal safety, it is important to observe these instru- ctions, which must be kept in a safe location for future con- sultation. • This manual contains important provisions for installation safety; incorrect installation procedures may lead to seri- ous hazards. • Partial reading of ...

EN outputs; fig. 1 shows the layout of the outputs on the termi- nal board. 2.1.1 - Output configuration Fig. 2 indicates the electrical circuit of the outputs: - the equivalent circuit (can be considered an electrical con- tact of a relay, voltage-free; - the real circuit can be considered the presence of a 100 Ω resistance in series with the c ...

Table 1: memorising devices on HSRE12 Control device Detector (all models) Door and window opening detectors (HSDID11) with alarm signal on opening and closing (alarm end) Remote control Keypad Control panel (with one of the 16 radio controls configured as: “PULSE”) Control panel (with one of the 16 radio controls configured as “ON-OFF� ...

EN 3.2 - Output function selection During memorisation of the devices, activation of the alarm can be programmed in the case of an alarm (Table 2); to do this, proceed as follows: 01. Select the required output by pressing S2 repeatedly (SEL.CAN); the relative led of the ALL output illuminates; 02. Press the key S3 repeatedly (PROG.OUT) to select ...

Table 2: output functions Type Led in programming Output contact response 1 Slow flash Closed, opens for 2 s in event of alarm 2 Quick flash Open, closes for 2 s in event of alarm 3 Always lit Open, closes for 180 s in event of alarm Note – in the case of devices that send ON-OFF commands, the relay output is always bistable (Off-On); in thi ...

EN 3.6 - Operation in alarm situations The alarm status can be displayed for a short time only (Dip Switch N°2 = OFF) or can remain memorised with the relative “ALL” (Dip Switch N°2 = ON). Detector alarm The transmission of a detector alarm causes switching of the relative output relay as programmed. Tampering alarm Opening of the receiver ...

TECHNICAL SPECIFICATIONS Warnings: • All technical specifications stated in this section refer to an ambient temperature of 20°C (± 5°C). • Nice S.p.a. reserves the right to apply modifications to products at any time when deemed necessary, maintaining the same intended use and functionality. Power supply: 12 V ± 2 V Absorption: 60 mA ...

EN CE DECLARATION OF CONFORMITY Declaration pursuant to Directive 199/5/EC Note - the content of this declaration corresponds to that declared in the official document filed at the office of Nice S.p.A. and, in particular, to its last revision available before this manual went to print. The text herewith has been re-adapted for editorial reaso ...