JLCooper Electronics SloMoPro Operation & User’s Manual

• Simultaneous Control of up to 16 VTRs or DDRs with the addition of the optional GangWay16 or GangWay32 • GPI Input and Output for control of VTRs or DDRs • Instant Replay feature for Blackmagic HyperDeck and Aja Ki Pro • Professional Jog mechanism • T-Bar c ...

connector to the rear of the SloMoPro. Secure the connector the SloMoPro by screwing the lock screws into the connector. Connect each video device or video server to the smaller 9 pin D-Sub connectors. Some video servers have more than one connector, which allow simulta ...

This sets the maximum speed to be sent by the T-Bar in Normal Mode when the T1 (Scaling) button is active. Note: Due to limitations of the P2 protocol, these speeds may not be exact. • 1x • 1½x • 2x • 4x • 8x • 10x 7. T-Bar Speed Preset Sets the Preset Speed to be evoked by pressing the Preset Button. Note: Due to limitations ...

JLCooper Electronics SloMoPro The following section introduces the controls on the SloMoPro and details the functions of those controls. System Functions Menu Pressing this button causes the SloMoPro to enter the configuration menu system. The Enter button is used to switch between the menu item and its parameters. Refer to the Configuration Menu section for more ...

JLCooper Electronics SloMoPro SHIFT button while applying power to the SloMoPro. After doing so, the display will show: Then the display will show: Follow the directions on the display. This calibrates the T-Bar for optimum range. These values are stored in nonvolatile memory and should never n ...

JLCooper Electronics SloMoPro target machine. The main modes are: Crash Recording Insure that neither the INS nor ASM LEDs are on. Holding down the Shift button, then pushing the PLAY button will place the machine(s) in the Crash Record mode. Assemble Recording Toggle the ASM button so that it ...

JLCooper Electronics SloMoPro This is only used by the Step Frame (Frame+1 and Frame-1) functions. This determines how the SloMoPro behaves at whole second boundaries. • 24 • 29.97 drop • 25 • 30 drop • 29.97 • 60 • 30 2. Record Enable Allows record and edit functions to be enabled or disabled. • Enabled • Disabled 3. T-Bar Range This sets ...

JLCooper Electronics SloMoPro 32 Configuring a Video Recorder for Instant Replay ..................................................... 33 .............................................................................. Blackmagic Design HyperDeck Series 33 Aja Ki P ...

JLCooper Electronics SloMoPro The table below details the pinout of the GPI connector on the rear panel of the SloMoPro. GPI Connector Transport Switch 1 Rewind 2 Stop 3 Fast Forward 4 W1 5 Ground 6 Reverse Play 7 Play 8 Shift 9 W2 The GPI Inputs/Outputs mirror the function of the common transport switches. The function of each GPI Inputs/Outputs is shown in the d ...

JLCooper Electronics SloMoPro perform instant replay of the video within the limitations of the video recorder. Typically traditional Instant Replay requires that the video device be able to simultaneously record incoming video while the video device plays back the video of interest. Unfortunatel ...