ParkerBrand PGBC-5200 Owner's Manual

product and referenced for operation, maintenance and troubleshooting. This manual contains an overall description of the product, together with all the necessary information for using the product correctly and safely. It is highly recommended that th ...

• ALWAYS USE safety equipment; appropriate footwear, eye protection, ear protection, head protection, trousers and gloves. • DO NOT wear loose clothing, jewellery, short trousers, sandals, or go barefoot. • NEVER sta ...

FOR SAFE OPERATION IMPORTANT • Read this manual carefully until you completely understand and can follow all safety and operating instructions • Keep this manual handy so that you may refer to it later whenever questions arise. Also note, if you have any questions which cannot be answered herein, contact Parker Brand. • Always be ...

FOR SAFE OPERATION USING THE PRODUCT • Grip the handles firmly with both hands using your whole hand. Place your feet slightly apart (slightly further apart than shoulder width) so that your weight is distributed evenly across both legs, and always be sure to maintain a steady, even posture while working. • Keep cutting attachment ...

MAIN ENGINE BULL HORN HANDLE BARS LOWER SHAFT + SPOOL AND BLADE HUB + BRACKET FOR LOWER GUARD TOOL KIT + SPARK PLUG WRENCH + ALLEN KEY WRENCH WASHER ‘A’ WASHER ‘B’ 3 TOOTH BLADE NUT 11 WHAT’S IN THE BOX SAFETY HARNESS THREE TOOTH BLADE LOWER GUARD SPOOL Washers and nut are pre-installed on the lower shaft. i ...

screws and tools provided. Loosen the four screws on the upper cap and place the bull horn handle inside. Re-tighten the four screws to secure the handle in position. 1 ATTACH THE LOWER GUARD 2 ATTACH THE HANDLE Over-tightening the bolts can cause damage to the screw and/or the machine. ASSEMBLY 1. ...

Install washer “A” as illustrated above. Align the hole in the washer with the hole in the spool collar. Lock the axle by placing the allen key inside the locating hole of the black collar and tighten the locking nut in an anti-clockwise direction using the wrench provided. Place the three tooth blade so the centre hole ...

2 ATTACH SPOOL HOUSING 1 INSTALL LOWER WASHER Install washer “A” as illustrated above. Align the washer with the hole on the spool collar. The purpose of this washer is to enable tightening of the nut by locking the shaft, this is done by inserting the allen key through the hole in the spool collar and into the hole in washer � ...

2 PRIME THE CARBURETTOR 1 FILL THE TANK Remove the fuel cap and fill the tank to no more than 80% capacity. Fuel should be a mixture of unleaded petrol and 2 stroke oil mixed at a ratio of 40:1 (Unless otherwise instructed). Prime the carburettor by repeatedly pressing the bulb located underneath the air filter housing. The fuel c ...