Raychem EMDR-10 Manual 

Moisture Sensor Fixing Brackets (Hard-46) Label Manual DEUtScH Lieferumfang Regelgerät Temperatursensor Feuchtesensor Abstandshalter (Hard-46) Aufkleber Montage- und Bedienungsanleitung FRaNçaIS Contenu du conditionnement Régulateur Sonde de température ambiante Sonde d’humidité Supports (Ha ...

Supplied Items ..........................................................................................2 1. Description ...........................................................................................5 1.1 Intended Purpose ...........................................................................5 1.2 Technical Data ...

Contenu du conditionnement ....................................................................2 1. Description .........................................................................................21 1.1 Domaine d’application .................................................................. 21 1.2 Caractéristiques tech ...

The electronic control unit EMDR-10 is specifically designed for the control of gutter heating systems. Depending on outdoor temperature and moisture in the gutter the heating cable will only be switched on if necessary to ensure a correct drain of the snow water. 1.2 technical Data control Unit Supply voltage 230 VAC, ±1 ...

IP 20 Relais: 10(4)A, AC 230V Alarm: 2(1)A, AC 230V Do not open while energized Nicht unter Spannung öffnen Ne pas ouvrir sous tension EMDR-10 T2A IEC127–2/V PE PE PE 1 2 3 4 5 6 7 8 9 10 11 °C –25 –20 –15 –10 –5 TEST °C –3 –2 –1 0 1 2 3 4 5 6 0 10 20 30 40 50 min 1 2 3 4 5 6 7 8 9 10 106 90 60 1.3 care and M ...

A good positioning of the temperature sensor is crucial for the correct and efficient operation of the snow melting system. The temperature sensor should be placed on the North side of the building, in a position where it will always be away from direct sunlight. Moreover, it must be protected agai ...

- The length of the heating cable determines number and size of the fuse. - The use of a FI safety switch (30 mA) is obligatory stipulated by Raychem! - Local standards for electrical connection must be observed. - The device may only be connected up by an authorized electrician. - Use C-characteristic circuit breaker! Maximum heating ...

The following parameters can be set by means of the respective dial: Adjustment of the air temperature threshold. The moisture sensor is being put into operation below this value. Adjustment of the moisture threshold. Above this value the heating cable is being energized, if the air temperature is below the setpoint. 1 = max. sens ...

The following faults are being detected by the control unit: Fault Reaction Break or short circuit of the temperature sensor LED “temperature“ flashes, alarm relay and load relay switch off Break of the moisture sensor LED “humidity” flashes, Short circuit of the moisture sensor alarm relay and load relay swi ...