PRÜFTECHNIK EDDYTHERM Operating Manual

3 Table of contents Preface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Safety precautions and operating notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7 Safety precautions .......................................... ...

28 Troubleshooting Indicator LED does not light up and there is no display The connector is not plugged in  Remedy: Plug the power cord into the power socket or check whether the power socket is energized. The micro fuse is blown  Remedy: Contact your PRÜFTECHNIK representative. Indicator LED lights up, but heater is not working ...

PRÜFTECHNIK EDDYTHERM 32 EDDYTHERM® is a registered trademark of PRÜFTECHNIK Dieter Busch AG. No copying or reproduction of this information, in any form whatsoever, may be undertaken without express written permission of PRÜFTECHNIK Alignment Systems GmbH. The information contained in this leaflet is subject to change without further notice due to ...

PRÜFTECHNIK EDDYTHERM 24 Timed shutoff In this operating mode, the workpiece is heated for the duration set and then demagnetized. A temperature probe does not need to be connected in this heating mode. Step-by-step instructions: 1. Mount the workpiece on the EDDYTHERM. 2. If the workpiece temperature is to be checked during heating, mount the temperat ...

PRÜFTECHNIK EDDYTHERM 10 Type Ser.Nr. Herst.Dat. V˜/A COSφ kW/kVA Hz/Phasen CISPR 11/IEC 55011 Klasse B Zeichn.Nr. Gew., kg PRÜFTECHNIK Alignment Systems GmbH D-85737 Ismaning www.pruftechnik.com Operating notes To ensure that the equipment operates smoothly, note the following instructions. Temperature range Operation The allowable operating temper ...

PRÜFTECHNIK EDDYTHERM 9 Before setting up  Read the operating instructions carefully and familiarize yourself with the controls.  The equipment may only be operated and serviced by trained personnel.  The operating instructions are an integral part of EDDYTHERM and must be always be legible, complete and available to anyone working with the device.  ...

PRÜFTECHNIK EDDYTHERM 27 Faults and error messages EDDYTHERM is equipped with an overload protection (automatic fault detection unit) to prevent damage to the device or to the roller bearings being heated. Error messages MIN C F Appears if a temperature probe is not connected in the “temperature hold” or “temperature shutoff” operating modes. ...

PRÜFTECHNIK EDDYTHERM 14 Starting EDDYTHERM EDDYTHERM 4x cable holder EDDYTHERM 4x is provided with a bracket upon which excess power cable may be hung to avoid damage or the danger of tripping. Setup Simply plug the heater into the power socket. The indicator LED for the “temperature shutoff” operating mode lights up. Switching off If the induction ...

PRÜFTECHNIK EDDYTHERM 13 EDDYTHERM control panel Brief description of operating modes and functions Temperature hold The workpiece is heated to the set temperature and held at that temperature until it is needed. It is automatically demagnetized before it is removed. Temperature shutoff The workpiece is heated to the set temperature and then demagnetize ...

18 Bearings with brass or bronze cages When bearings with brass or bronze cages are to be heated, care must be taken to ensure that the cage does not heat faster than the inner bearing ring. This could cause the lubrication contained in the bearing pockets to become overheated, which in turn could, in extreme cases, lead to overhea ...