Vonets VM300 Quick Setting Manual

8 4. “WiFi Tx Power” of VONETS module can be changed, jump to “System Settings”---- “Advance Settings”, choose suitable transmit power, then click “Apply”; 5. Reboot device, jump to “System Settings”---- “Reboot Device”, click “Reboot”, when it is finished, all revised options will take effort. Remark 2: ...

Vonets VM300 3 Chapter 2 Bridge+Repeater Mode Configuration Instruction 2.1 Device Connection Power on VONETS module by 5V/2A power supply, then connect to PC, there are two connection ways as below: A. Computer is wired connected to LAN port of VONETS module; （Recommend Method） ...

Vonets VM300 15 2. Revise WiFi password, in “WiFi Repeater”----“WiFi Security”, enter new WiFi password in “Pass Phrase”, click “Apply”; 3. Reboot device, jump to “System Settings”---- “Reboot Device”, click “Reboot”, when it is finished, all revised options will take effort. ...

11 3.2 WAN port setting 3.2.1 WAN/LAN exchange In routing mode, the Ethernet port of VONETS module is divided into a WAN port and a LAN port, and WAN/LAN can be interchanged. The Ethernet port of VM300 module defaults to WAN port. The Ethernet cable defaults to LAN port. If the interface mode is changed to “WAN/LAN exchange”, th ...

Vonets VM300 10 2. After computer is connected to VONETS module, open browser, input configured page domain name: http://vonets.cfg (or IP: 192.168.254.254), then press Enter; 3. Enter User name and Password in login page (both are “admin”), click “Login” button to enter configured page; 4. In “Operating Mode”, change Device mode to ...

Vonets VM300 6 5. Click “Reboot”, VONETS module will connect to the configured WiFi hotspot automatically, if connection is successful, the WiFi LED light will flash quickly; Remark 1: LED Light Form Model Blue Light Green Light Yellow Light VM300 2.4G WiFi Connection Status Light Ethernet Cable Connection Status Light / VM5G 2.4G WiFi Conne ...

Vonets VM300 16 Appendix Frequently Asked Questions 1. How to reset to the factory default parameters? Please refer to the information below to reset the factory default parameters of the VONETS module.： VM300: http://www.vonets.com/serviceView.asp?D_ID=213 VM5G: http://www.vonets.com/serviceView.asp?D_ID=306 2. Does VONETS module support firm ...

Vonets VM300 4 B. The computer wirelessly connects to the WiFi signal of VONETS module, its default hotspot parameters are as follows: WiFi SSID WiFi Password VONETS_2.4G_**** 12345678 VONETS_5G_**** 12345678 (After the WiFi parameters are configured, the WiFi will be disconnected, that is normal.) 2.2 Bridge+Repeater Application Configuration T ...

Vonets VM300 2 1.2 Router Mode ⚫ VONETS module as WiFi router The Ethernet port of VM300 module defaults to WAN port. The Ethernet cable defaults to the LAN port. WAN and LAN ports are interchangeable. The Ethernet cable of VM5G module defaults to LAN port, you must set “WAN/LAN interchange” so that the Ethernet cable is WAN port to use th ...

Vonets VM300 14 Detection and SSA Signal strength alarm threshold,these options here can be kept unchanged, for instructions on this option, go to www.vonets.com and download the “V Series WiFi Bridge Advanced Features Instruction”; 4. Click “Reboot”, VONETS module will connect to the configured WiFi hotspot automatically, if connection ...