Record Power PT260 Instruction Manual

instructions carefully before assembling or using this product. Save this manual for future reference. Planer Thicknesser PT260 Holywell Road Sheffield S4 8AS Tel: 0114 244 4238 Fax: 0114 244 9098 www.tt-hire.co.uk email [email protected] ...

Health & Safety Guidance page 4 Additional Safety Instructions For Planer Thicknessers page 5 Record Power Guarantee page 6 EU Declaration Of Conformity page 29 User Manual 1. Getting to know your planer thicknesser page 7 2. Machine specification page 7 3. Stand & wheel kit assembly page 8 4. Machine assembly page 11 5. ...

CAREFULLY BEFORE ASSEMBLY, INSTALLATION AND USE OF THIS PRODUCT. KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE. WARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury. SAFE OPERATION 1. Eye Protection. The op ...

COMMON SENSE AND ALERTNESS AT ALL TIMES WHEN THE PLANER THICKNESSER IS BEING USED. WARNING: FOR YOUR OWN SAFETY, DO NOT ATTEMPT TO OPERATE YOUR PLANER THICKNESSER UNTIL IT IS COMPLETELY ASSEMBLED AND INSTALLED ACCORDING TO THE INSTRUCTIONS. SAFE OPERATION 1. Regularly check that the blades and lock bars are locked tight in ...

B On / off & emergency stop C Cutter guard D Infeed table E Outfeed table F Fence assembly G Planing depth of cut adjustment H Cutter guard rise and fall I Machine frame J Stand & wheel kit K Planing extraction port (100mm) L Thicknessing table M Thicknessing rise and fall handle N Thicknessing extra ...

Set thicknessing bed to approximately 2/3 capacity and place extraction connector on to it. Raise thicknessing bed to secure extraction connector in position Fig.6.1 Note: Ensure that the notches in top of the connector locks in the spacer shaft & depth of cut adjusting bar. Note: We recommend adequate dust extraction must be us ...

ening a workpiece and for trimming the long side of panels. Place workpiece flush on to in-feed table, with your left hand set the cutter guard to the required height (workpiece should be run clear of the guard. Start machine and push stock slowly and steady against the cutter- block. Hands slide over t ...

described under CHIP REMOVAL WHEN THICKNESSING. Set thicknessing bed to required thickness of workpiece (but a maximum 5mm more than actual thickness of the workpiece) Fig.6.8. 2. Start machine and place workpiece with planed side facing down on to thicknessing bed and slowly push forward until feed rol ...

regularly clean the thicknesser drive gear using a brush or compressed air. 2. Lubricate all bearing points and chains regularly with a few drops of motor oil. Keep flat belt free of oil and grease. WARNING: If blowing sawdust, wear proper eye protection to prevent debris from blowing into eyes. 3. Clean the thicknessing ...

close contact with the planer blade. Ensure that gloves are worn at all times to prevent injury to the hands. To remove the planer knives 1. Disconnect the machine from the electricity supply. 2. Remove the planer fence. 3. Raise the cutterblock guard extrusion and pull it outwards fully. 4. Turn each of the ...