BenQ CinePrime W2700 Operation & User’s Manual

Warranty and Copyright information Limited warranty BenQ warrants this product against any defects in material and workmanship, under normal usage and storage. Proof of purchase date will be required with any warranty claim. In the event this product is found to be defective within the warranty period, BenQ's only obligat ...

Table of Contents Warranty and Copyright information ................................................................................ 2 Important safety instructions .............................................................................................. 4 Introduction .............................................................. ...

Important safety instructions Your projector is designed and tested to meet the latest standards for safety of information technology equipment. However, to ensure safe use of this product, it is important that you follow the instructions mentioned in this manual and marked on the product. 1. Please read this manual before yo ...

9. Never replace the lamp assembly or any electronic components unless the projector is unplugged. 10. Do not place this product on an unstable cart, stand, or table. The product may fall, sustaining serious damage. 11. Do not attempt to disassemble this projector. There are dangerous high voltages inside which may cause de ...

17. Do not place liquids near or on the projector. Liquids spilled into the projector may cause it to fail. If the projector does become wet, disconnect it from the power supply's power outlet and call BenQ to have the projector serviced. 18. This product is capable of displaying inverted images for ceiling/wall mount installa ...

please contact your place of purchase. Standard accessories Optional accessories Replacing the remote control batteries 1. Press and open the battery cover, as illustrated. 2. Remove the old batteries (i ...

1. Lamp cover 2. Adjuster feet 3. Projection lens 4. IR remote sensor 5. External control panel (See Controls and functions on page 9.) 6. Lens shift wheel 7. Zoom ring 8. Focus ring 9. Kensington anti-theft lock slot 10. Vent (air inlet) 11. 12V DC output terminal Triggers external devices such as an electric ...

Projector & Remote control 1. OK Confirms the selected On-Screen Display (OSD) menu item. When Keystone OSD pops up, long press for 2 seconds to reset Keystone. 2. POWER Toggles the projector between standby mode and on. ON/ Off Toggles the projector between standby mode and on. 3. BACK Goes back to previous OSD ...

The remote control must be held at an angle within 30 degrees perpendicular to the projector's IR remote control sensor(s) to function correctly. The distance between the remote control and the sensor(s) should not exceed 8 meters (~ 26 feet). Make sure that there are no obstacles between the remote control and ...