Record Power BS300 Instruction Manual

instructions carefully before assembling or using this product. Save this manual for future reference. Mid Sized Bandsaw BS300 ...

Health & Safety Guidance page 4 Additional Safety Instructions For Bandsaws page 5 Record Power Guarantee page 6 User Manual 1. Getting To Know Your Bandsaw page 7 2. Machine Specification page 7 3. Initial Assembly page 8 4. Stand & Wheel Kit Assembly page 12 5. Setting Table Square To Sawblade page 16 6. Bandsaw Blade ...

CAREFULLY BEFORE ASSEMBLY, INSTALLATION AND USE OF THIS PRODUCT. KEEP THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE. WARNING: When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock and personal injury. SAFE OPERATION 1. Eye Protection The ope ...

COMMON SENSE AND ALERTNESS AT ALL TIMES WHEN THE BANDSAW IS BEING USED. WARNING: FOR YOUR OWN SAFETY, DO NOT ATTEMPT TO OPERATE YOUR BANDSAW UNTIL IT IS COMPLETELY ASSEMBLED AND INSTALLED ACCORDING TO THE INSTRUCTIONS. SAFE OPERATION 1. The bandsaw should be bolted to the floor where possible. 2. If you are not thoroughly ...

1. INTRODUCTION 1.1 We supply machinery through a network of dealers and authorised distributors and you should be aware that your contract of sale is with the retailer from whom you purchased this product. 1.2 If you are not satisfied with this product you should in the first instance approach the retailer from whom you purchased it. ...

Fig.1 A Blade Tensioning Knob B Rise & Fall Hand Wheel C Blade D Blade Guide E Table F Rip Fence Assembly G Rip Fence Rail H Lock Handle I Stand & Wheel Kit J Belt Tension & Speed Change Handle K Blade Tension Release Cam Handle L Rise & Fall Lock Knob M Blade Tracking Knob N Table Tilting Knob O Motor ...

The machine is supplied partly assembled. Prior to use, the following items have to be fitted: bandsaw table, rip fence guide, crank handle and guide post handwheel and the wheel kit. When unpacking the machine the following components are included for the initial assembly Fig.3.1: Fig.3.1 1 2 3 5 6 7 ...

Fig.3.4 TABLE FIXING BOLT & WASHER TRUNNION Fig.3.5 TRUNNION Fig.3.6 FENCE BAR TABLE FIXING BOLT & WASHER 8 9 3.2 Rise & fall hand wheel Attach large crank handle to rise and fall mechanism with 14mm spanner (not supplied) (See Fig.3.2). 3.3 Belt tension handle Attach small crank handle to belt tension and speed mechanism with 10m ...

1. Unscrew the locking nuts from the mitre fence Fig 3.7. 2. Place the protractor with the flat edge running parallel to the mitre fence. 3. Position it in such a way that the fence screws slot into the holes on the protractor Fig 3.8. 4. Replace and re-tighten the locking nuts. 5. Position the slide underneath the protractor s ...

Locate fence assembly onto the fence bar. Position the fence on to the table and lock off by screwing on and tightening the fence lock knob. (See Fig.3.12). 3.8 Fence alignment 1 Align the fence assembly in or out until parallel with the side of the blade (See Fig.3.13) by adjusting the fence bar nuts accordingly. 3.9 Fence al ...