Alton EVOLUTION FIVE Instruction Manual

Assembly Instructions Contents: Introduction Base Preparation Overview Base Assembly Side Assembly Rear Assembly Front Assembly Roof Assembly Louvre Assembly Glazing Door Installation Roof Vent Installation Frame Finishing Gutter and Downpipe Installation Optional Auto Louvre Installation Parts Lists Section - 1 2 3 4 5 ...

goggles, gloves, headgear and suitable footwear when assembling and glazing the building.  Please remember that glass is fragile and should be handled with extreme care. Always clear up and dispose of any breakages immediately.  Do not assemble th ...

and also to allow for the possible need to replace a piece of glass in the future. If possible try and leave a space of 2ft/610mm around the greenhouse. Locate the greenhouse where there is maximum amount of sunlight and avoid if possible any shade from tr ...

(Stainless Steel) 40mm Pan Head (Stainless Steel) 50mm Countersunk (Stainless Steel) 80mm Countersunk (Stainless Steel) Fixes all capping and metalwork Secures Timber Cladding Fixes glazing bars to ridge and cills Secures the roof and side glazing bars to the eaves in one go! 19mm Pan Head (Stainless Steel) Fixes the ridge hinge (aluminium op ...

break into tiny peaces if you catch an edge on a hard surface such as concrete. You should also wear suitable gloves when handling the glass (this also helps to keep it clean). It is good practice to pre- load the bar capping with screws and pos ...

example D174M EV0293M EV0287M Dia. 2 Dia. 1 EV0293M Base Assembly 3 Lay out your aluminium base sections as the diagram shows. Insert bolts in the bolt channels for attaching the base brackets (HE300), diagram 1. The base brackets should always be positioned either side of the door, in the corners, in the middle of the rear a ...

ground like the diagram below. Use the tables below to identify your building length and the components with the part numbers and sizes. First of all drill pilot holes through the bottom of each mortise on the cill section (diagram 1, page 9). Then slot each ...

way in, you may find they need a light tap with a wooden mallet or something similar. If you are going to glue your joints this is the first point you would do this. 50mm Screw Pilot hole, it is easiest to drill down through the middle o ...

Drill two pilot holes in the bottom of the side corner bar as in diagram 4. The height of these holes should be about 15mm on the side face and 25mm on the rear face measured from the end of the bar, try t ...