Zektor HDVI5 Manual 

Home Theater Switches Digital Video / Component Video / Multichannel Audio Rev 1 02/28/2006 Digital Video Switch (Picture of HDVI5) HDVI5 PRELIMINARY (W.I.P.) all-guide s.com ...

 HDVI5 Component Video Switch Thank you for your purchase of your HDVI5 High Definition Compo- nent Video Switch. Every care has been taken to assure you of a successful installation and subsequent operations of your new HDVI5 video switch, however should something go wrong, and warranty repair work is needed, we request that ...

3 HDVI5 Component Video Switch 1 2 3 4 5 6 7 8 Front Panel Controls: Power Indicator. Lights up in standby mode. Selection LEDs. Indicate currently selected inputs. Select between Normal/Audio/Video Breakaway. Toggle Auxilary Relays. Input Selection Buttons. Infrared Remote Sensor Window. Infrared Received Indicator. Flashes wh ...

 HDVI5 Component Video Switch Initial Setup... Use the analog input connections to switch component video / composite video / analog audio or any combination of the above signals to the HDVI5’s analog output connec- tors. Use the digital audio connectors to switch digital au- dio signals, with automatic conversion between th ...

7 HDVI5 Component Video Switch Easy, Simple, Instructions! Auxiliary Relay Connections... The auxiliary relay contacts are rated at 30volts @ 5amps, and can be used to switch on and off anything you can think of within those limits. Each relay has a Normally Open connection, two Common connections, and a Normally Closed connect ...

9 HDVI5 Component Video Switch Three Simple Steps to a Remote! The HDVI5 features Zektor’s Exclusive Intelligent-IR™, and with very few exceptions can be setup to use any remote you can point at it! Pick a remote, any remote! Start by picking the remote you’d like to use with the HDVI5. If the remote you plan on using is ...

11 HDVI5 Component Video Switch Controlling the Front Panel Lights There are four different front panel light modes available on the HDVI5. They are: Front panel lights automatically fade from bright to dim after 4 seconds of inactivity. Front panel lights are always at the bright level. Front panel lights are always at the di ...

13 HDVI5 Component Video Switch 1 2 3 4 5 SEL A1 A2 Step 4: Select between Bright and Dim settings: Use SEL button. Step 5: Adjust Front Intensities. 1 2 ...

15 HDVI5 Component Video Switch 1 2 3 4 5 SEL A1 A2 Step 1: Set the HDVI5 to the preferred initial power on state Setup the HDVI5 to the initial power on state you’d prefer. In this ca ...

17 HDVI5 Component Video Switch Disabling Front Panel or Remote If you are using the rear panel IR jack, you might want to disable the IR sensors to prevent use of the remote control. Or if you have a household with young curious fingers that likes playing with buttons, you also have the capability of disabling the front panel ...