Trend Micro EdgeFire Quick Setup Manual

The EdgeFire is a highly integrated industrial multiport secure router with firewall / NAT / VPN / IPS and managed Layer 2 switch functions. It is designed for Ethernet-based security applications providing critical remote control or monitoring networks, and it provides an electronic security perimeter for the protection of critical cyber assets includ ...

Requirement Details Connect to the LAN port for web console management and WAN port for external network. Default access information: https://192.168.127.254 • IP address must be configured for WAN or LAN usage. Ethernet Cables Default IP Address of Web Console The computer must have one of the following browsers installed: - Microsoft Edge (versio ...

LED Indicators 14 The function of each LED is described in the table below Green Power 1 is OFF Off Power 1 is ON PWR1 Green Power 2 is OFF Off Power 2 is ON PWR2 Green System failure Off The system is running STATE Red System is running without fault Off System failure FAULT Green OT Defense Console sync is disabled Off OT Defense Console sync is enab ...

Installing the EdgeFire - DIN Rail Mounting 16 The aluminum DIN rail attachment plate should already be fixed to the back panel of the EdgeFire when you take it out of the box. If you need to reattach the DIN rail attachment plate to the EdgeFire, make sure the stiff metal spring is oriented towards the back, as shown in the following pictures. 1x Moun ...

Wiring the Redundant Power Inputs 17 The Trend Micro EdgeFire has two sets of power inputs – power input 1 and power input 2. The top and side views of the terminal block connector are shown below. Step1. Use a small flathead screwdriver to open the locks on the terminal block. Step2. Insert a positive / negative DC wire into the V+/V- terminals resp ...

Wiring the Redundant Power Inputs 17 Software Configuration 110 Before connecting the PC/Laptop to the EdgeFire, the PC's IP address should be set to 192.168.127.100. After that, connect the PC to the LAN port of the EdgeFire using an Ethernet cable. Open a web browser on your PC and type “https://192.168.127.254” into the address bar. A pop-up wi ...

Setting the Management IP Address 111 1. Go to [ Network ] > [ Network Interface ] Connecting to the Network 112 Task Action Configure Management IP Address of the EdgeFire IP Address Configure Netmask of the EdgeFire Subnet Mask Configure Network VLAN-ID of the device Network VLAN-ID 2. Click on a LAN interface, the [Edit Network Interface] screen wil ...

No Light The EdgeFire cannot communicate with the network. RJ45 Checking the LED to Confirm Status 113 The LED on the front panel shows the deployment status. Only Left LED 10Mbps LINK/ACT (off = no link, on = 10 Mbps, blinking = activity) Only Right LED 100Mbps LINK/ACT (off = no link, on = 100 Mbps, blinking = activity) Both Left / Right LED GE LINK ...

© 2020 Trend Micro Incorporated. All Rights Reserved. Trend Micro and the t-ball logo are trademarks or registered trademarks of Trend Micro Incorporated. All other company and/or product names may be trademarks or registered trademarks of their owners. Information contained in this document is subject to change without notice. Contact Information 1 W ...