Proxim MP11 5012-SUI Quick Install Manual

Page 23 Basic Configuration System Configuration The System configuration page lets you change the unit’s System Name, Location, and so on. In addition, this page provides a selectable Country field that automatically provides the allowed bandwidth and frequencies for the selected country/band. Units sold only in the United States are p ...

Page 9 Step 2: Unpack Shipping Box Unpack the unit and accessories from the shipping box. Note the Ethernet and MAC addresses of the unit, as well as the serial number. The addresses may be used when configuring the unit. The serial number is required to obtain support from Proxim. Keep this information in a safe place. 1. 2. ...

Proxim MP11 5012-SUI Page 17 Step 8: Connect the Pigtail Cable The pigtail cable has a sub-miniature A-type (SMA) connector on one end and an N-type connector on the other. It is used to connect an external antenna to the 5012/5054-SUI (see figure). To install the pigtail cable: Place the 5012/5054-SUI on a table. The compartment cover closer to the LED pan ...

Proxim MP11 5012-SUI Notices Copyright Copyright ©2007 Proxim Wireless Corporation, San Jose, CA. All rights reserved. Covered by one or more of the following U.S. patents: 5,231,634; 5,875,179; 6,006,090; 5,809,060; 6,075,812; 5,077,753. This manual and the software described herein are copyrighted with all rights reserved. No part ...

Proxim MP11 5012-SUI Step 4: Install the Security Cover (Optional) You can optionally install a security cover to deter unauthorized access to the 5012/5054-SUI. The security cover is a plastic enclosure that prevents access to the cabling and the Reset and Reload buttons. Open the split end of the security cover just enough to slide the ...

Proxim MP11 5012-SUI Ceiling Mounting Follow these steps to mount the unit to a ceiling: If the unit’s power supply is plugged in, unplug it. Identify the location at which you intend to mount the unit. Snap the rectangular tabs on the back of the mounting plate onto a ceiling T-bar. You may need to slightly rotate the plate until it s ...

Proxim MP11 5012-SUI Page  Hardware and Software Installation Note: Be sure to read the Release Notes as they contains software version and driver information that may not have been available when this document was produced. IMPORTANT! Before installing this product, see Safety and Regulatory Compliance Information on the product CD for important information ...

Replace the cover by aligning the two bottom tabs inside the holes (A) on each side of the compartment. Ensure that the cable will not get pinched by the cover. Slide the cover towards the center of the unit until it snaps on place. Replace one of the small plastic caps onto the remaining open hole on the front. R ...

Proxim MP11 5012-SUI Page 21 Initialization Connecting to the unit requires either: A direct physical connection with an Ethernet cable or with a serial RS-232 cable A network connection Connecting with the Ethernet cable allows you to use of the Web Interface and SNMP in addition to the CLI. Connecting with a serial connection allows you to configure and ma ...

Proxim MP11 5012-SUI Step 3: Attach Cables Cabling without Power Over Ethernet (PoE) Plug the barrel of the power cable from the power supply into the power jack (the leftmost port in the back of the unit, see figure). Connect one end of an Ethernet cable (not supplied) to the unit’s LAN port (see figure). The other end of the cable s ...