PerkinElmer LAMBDA 265 Assembly/installation Instructions

Shelton, CT 06484-4794, U.S.A Produced in the USA. Lambda 265, 365 and 465 Manual Magnetic Stirrer Assembly Installation Instructions This instruction sheet describes the installation of this accessory which is used with the Lambda 265, 365 and 465 Spectrophotometer. NOTE: Read these instructions before you inst ...

Description Configuration of the Magnetic Stirrer Assembly Figure 2 Configuration Physical Characteristic Specification Dimensions (mm) 65 (W) x 50 (D) x 45(H) Weight (g) 79 Speed (rpm) 120 ~ 1,200 Stirring Power (W) 10 Operating Condition 0~40℃, 80% Humidity Power AC 100-240 V / 50-60 Hz / 0.4 A ...

Accessory Drawing Single Cell Holder Water Jacketed Single Cell Holder Compatible Lambda 365 Cell Holders to Magnetic Stirrer Assembly Accessory Drawing Single Cell Holder Water Jacketed Single Cell Holder Micro Cell Holder ...

Accessory Drawing Single Cell Holder (Upon request) Water Jacketed Single Cell Holder (Upon request) 8 Cell Water Jacketed Cell Changer Water Jacketed Automatic Referencing Stage  Where, the cell holder will be modified to be connected with the magnetic stirrer only upon request. ...

CAUTION ATTENTION Make sure the instrument is turned off while installing this accessory. Assurez-vous que l’instrument est éteint lors de l’installation de cet accessoire. 1. Connect the plug of the power cable to the power input socket of the control unit. Figure 3 Connecting the power cable 2. Connect the stirrer c ...

Figure 6 Inserting the stirrer head 5. Assemble the single cell holder with the stirrer head inserted, and tighten the screw using the M3 wrench. Figure 7 Assembling the single cell holder ...

CAUTION ATTENTION Make sure the instrument is turned off while installing this accessory. Assurez-vous que l’instrument est éteint lors de l’installation de cet accessoire. Connect to Single Cell Holder 1. Connect the plug of the power cable to the power input socket of the control unit. Figure 8 Connecting the plug 2 ...

Figure 10 Removing the screw 4. Insert the stirrer head of the stirrer control cable into the single cell holder. Figure 11 Inserting the stirrer head 5. Assemble the single cell holder with the stirrer head inserted, and tighten the screw using the M3 ...

1. Connect the plug of the power cable to the power input socket of the control unit. Figure 13 Connecting the plug 2. Connect the stirrer control cable to the 4-pin socket of the control unit. Figure 14 Connecting the stirrer control cable 3. Using the M3 wrench, remove the screw in the water jack ...

Figure 16 Inserting the stirrer head 5. Assemble the water jacketed single cell holder with the stirrer head inserted, and tighten the screw using the M3 wrench. 6. Using the screw driver remove the M2.5 Phillips round head screw with washer (M3*1 ...