Peradon DCT Conversion Instructions

old £1 coin to new £1 coin DCT / ADM & SCT 128 Richmond Row – Liverpool – L3 3BL Tel : 0151 298 1470 Fax : 0151 298 2988 email : [email protected] web : www.peradon.co.uk all-guides com ...

The conversion kits should contain the following items: - Pre 2011 DCT 1 x wall bracket fitted with new coin entry plate 1 x runway 1x double sided VHB tape Post 2011 DCT 1 x coin entry plate ADM & SCT 1 x safety plate 1 x coin acceptor Tools Required No. 1 9 inch pozidrive screwdriver ...

1 Switch off electricity supply. 2 Remove cash box. 3 Unlock front cover and lift upwards allowing lower part of cover to come towards you. Pull cover forwards and away from wall bracket and disconnect lead from the power supply board (PSU). See Figure 5. 4 Disconnect electrical connections marking the position of wires and remove wall bracket f ...

Optional earth block Terminal Block Relay Figure 3 Figure 4 8 Fit new runway supplied ensuring the lugs are correctly located in the corresponding holes (Figure 3). 9. Re-fit runway cover and insulation plate using retained screws. Attach wall bracket to the wall and re-connect electrical connections ensuring they they are re-connect ...

1 Switch off electricity supply. 2 Remove cash box. 3 Unlock front cover and lift upwards allowing lower part of cover to come towards you. Pull cover forwards and away from wall bracket and disconnect lead from the power supply board (PSU). See Figure 5. 4 Remove two screws from insulation plate and remaining screw holding runway cover and put ...

1 Switch off electricity supply. 2 Remove cash box. 3 Insert a No. 1 nine inch pozidrive screwdriver through the hole uncovered by removing the cashbox and remove the recessed screw holding the front panel (Figure 9). 4 Remove the front panel by pushing downwards as far as possible, pulling the bottom edge slightly outwards and then lifting panel u ...

the coin acceptor and remove coin acceptor keeping all fixings. 9 Fit new coin acceptor supplied using retained fixings ensuring earth is correctly fitted. Tighten securely. Refit circuit board(s) and 5-way connector ensuring correct connection (Figures 15 and 16). 10 Refit spade termin ...