Rheem EON Quick Start Manual

EON Control for Replacing ECM 2.3 or EON motor Control control and motor enough to reach inside and detach the 3- pin connector between the motor and control by pushing on tab (see Figure 2a and 2b). Figure 2a: Figure 2b: 3 motor leads to EON control 3 motor leads to 2.3 control 4. Validate motor is not defective see Figure 3: first ...

Rheem EON EON Control for Replacing ECM 2.3 or EON motor Control 10. Place the two 2.76-inch bolts into the holes at the base of the new EON control and tighten down to a torque measurement of 15-19 inch pounds. 11. Reattach the 5-pin power cable and 16-pin signal cable into the unit connector. Installing connectors incorrectly may result in ...

Rheem EON EON Control for Replacing ECM 2.3 or EON motor Control This control cannot be used on ECM2.0 motors. For ECM2.0 motors replace entire motor with specified Eon Motor/module assembly. NOTE: Read the entire instruction manual before starting the installation. SAFETY CONSIDERATIONS GENERAL WARNINGS Installing and servicing of heating ...