Hach Flo-Dar Basic User Manual

Basic User Manual Basis-Benutzerhandbuch Manuale di base per l'utente Manuel d'utilisation de base Manual básico del usuario Manual Básico do Usuário Podstawowa instrukcja obsługi Grundläggande bruksanvisning Temel Kullanım Kılavuzu Osnovni uporabniški priročnik ...

English..............................................................................................................................3 Deutsch.......................................................................................................................... 30 Italiano.................................................................. ...

6 Operation on page 25 7 Maintenance on page 25 Table of Contents 1 Table of contents on page 3 2 Expanded manual version on page 3 3 Specifications on page 3 4 General information on page 4 Section 2 Expanded manual version For additional information, refer to the expanded version of this manual, which is available on the manufactu ...

Method: Piezo resistive pressure transducer with stainless steel diaphragm Auto zero function maintains zero error < 0.5 cm (0.2 in.) Range: 3.5 m (138 in.); overpressure rating: 2.5 × full scale Velocity measurement Method: Pulsed radar - Doppler Range: 0.23–6.10 m/s (0.75–20 ft/s) Frequency Range: EU M ...

equipment in any manner other than that specified in this manual. 4.1.1 Use of hazard information D A N G E R Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury. W A R N I N G Indicates a po ...

law. This standard directly affects more than 250,000 industrial sites in the United States and was created to protect the health and safety of workers in confined spaces. Definition of a confined space: A confined space is any location or enclosure that has (or h ...

correct the interference at their expense. The following techniques can be used to reduce interference problems: 1. Disconnect the equipment from its power source to verify that it is or is not the source of the interference. 2. If the equipment is connected ...

1 Flo-Dar sensor with optional surcharge velocity sensor 3 Mounting frame 2 Flow logger or controller 4 Non-hazardous environment 4.4 Product components Make sure that all components have been received. Refer to Figure 2 and Figure 3. If any items are missing or damaged, contact the manufacturer or a sales representative imm ...

1 Flo-Dar sensor 4 Surcharge velocity sensor (SVS) (optional) 2 Extended range sensor (optional) 5 Flo-Dar connector and SVS connector 3 Bubble level 6 Flo-Dar with bare-wire and SVS with bare-wire 1 Figure 3 Wall mount hardware 1 Wall mount bracket 7 Standard frame 2 Spacer, 12-inch 8 Spacer, 2¼-inch 3 ...

D A N G E R Explosion hazard. Trained personnel only must install or commission the equipment. 5.1 Mechanical installation 5.1.1 Site location guidelines N O T I C E To prevent damage to the enclosure, install the instrument away from direct sunlight, ultraviolet radiation (UV), heat sources and severe weather. Install a sun shade or p ...