ESI Solution 3 Instructions Manual

Solution 3 ARTICULATING ARM and KEYBOARD PLATFORM SOLUTION 3 Rev A 4/17 Model SOLUTION 3 SOLUTION 3 ...

all parts needed were provided with your order. Contact your supplier if any operates to your satisfaction. Solution 3 combines the AA360 articulating arm with the PL215 keyboard platform. In this instruction booklet, installation of the two products will be explaine ...

STEP 2: Attach Track • Drill 1/8" pilot holes through all 11 holes in the track. — Drill the holes 5/8" deep or 1" deep, depending on which wood screws will be used. (A minimum work surface thickness of 11/2" is recommended for the 1" screws.) CAUTION: Be careful not to drill through the w ...

• Phillips screwdriver • Allen key (if changing mouse sides) PL215 PARTS PROVIDED Keyboard Platform (1) Palm Rest (2) 1 Each for Keying and Mousing Flathead Screw (4) Flange Nut (4) Cord Clips (2) Panhead Screw (4) #8-32x1/2 #8x32 #8-32x5/8 CAUTION: Hand-tighten screws o ...

• Attach the keyboard platform to the keyboard arm and track assembly using the four flathead screws and flange nuts. — Be sure the flange on the nuts is facing upward. IMPORTANT: The flange nuts must be fully tightened to ensure the nuts are locked. Use a Phillips screwdriver. Flathead Screw Flange Nut Flath ...

• Tip the platform up to unlock. • Move the platform to the desired height. • Release the platform to lock it in place. To Set Tilt Angle: • Unlock the quick release handle on the right side of the arm. • Adjust the tilt angle to the desired position. • Lock the quick release knob. To Use the Mou ...

SOLUTION 3 Rev A 4/17 ...