Arctic King WDK Series Operation & User’s Manual

this product, please read this manual carefully and keep it for future reference. The design and specifications are subject to change without prior notice for product improvement. Consult with your dealer or the manufacturer for details. Rated voltage: 115V Frequenc ...

Inside you’ll find many helpful hints on how to use and maintain your air conditioner properly. Just a little preventive care on your part can save you a great deal of time and money over the life of your air conditioner. You’ll find many answers to common problems in the troubleshooting tips - you should be able to fix most of th ...

shown here must be followed. Incorrect operation due to ignoring of instructions may cause harm or damage. The level of risk is shown by the following indications. • Plug in power cord plug properly. Otherwise, it may cause elect ...

Lack of ventilation can cause overheating and fire. • Do not use in places where water may splash onto the unit. Water may enter the unit and degrade the insulation. It may cause an electric shock or fire. • Place the unit on a level, sturdy section of the floor. If the unit falls ...

• The manufactures nameplate is located on the rear panel of the unit and contains electrical and other technical data specific to this unit. • Be sure the unit is properly grounded. To minimize shock and fire hazards, proper grounding is important. The power cord is equipped with a three-prong g ...

Unit Specifications and Features Product overview Accessories NOTE All the pictures in this manual are for illustrative purposes only. The actual shape of the air conditioner you purchased may be slightly different, but its operations and fuctions are similar. Front 1. Control panel 2. Air intake grille 3. Air outlet g ...

Control Pads 1. FILTER Pad The check filter feature is a reminder to clean the Air Filter for more efficient operation. The Filter light (Clean filter light) will flash after 250 hours of operation. To reset after cleaning the filter, press the Filter pad and the light will go off. 2. Mode ...

Press to initiate the Auto start and Auto stop feature, in conjuction with the and key pads. 5. Up/Down Pads ( / ) • Humidity Set Control Pads The humidity level can be set within a range of 35% RH (Relative Humidity) to 85% RH (Relative Humidity) in 5% increments. For drier air, press the pad and set to a lo ...

• When the unit is on, first press the Timer button, the Timer OFF indicator light illuminates. It indicates the Auto stop program is initiated. Press it again the Timer ON indicator light illuminates.It indicates the Auto start is initiated. • When the unit is off, first press the Timer button, the Timer O ...

There are two ways to remove collected water: 1. Use the bucket • When the unit is off, if the bucket is full, the unit will beep 8 times and the Full indicator light will flash, the digital display shows P2. • When the unit is on, if the bucket is full, the compressor turns off and the fan turns off after 30 seconds for ...