APS RMC Rack Multi Control Manual 

Cleaning ……………………………………………………………………………………………. 3 Installation …………………………………………………………………………………………..3 Moun ...

For your own safety, please read this manual carefully and follow the instructions. Improper handling can damage the device. Cleaning: Do not use any liquid cleaner or corrosive agent but only a dampened cloth. Installation:  Installation should be performed by certified personnel only.  Use caution when mounting sensors o ...

 Inputs 1 and 2 have a 24V supplied (10mA max) for powering external sensors, e.g. a smoke detector.  Inputs 3 and 4 are potential free.  Inputs 5, 6, 7 and 8 have the same characteristics as Input 1 und 2.  The 24 VDC supply voltage is protected against short circuits. ...

The Alarm/Door Relays (max. 1A) are connected as follows:  Output for Alarm and Door are potential free. The output “Relay Alarm” can be used for an external horn or warning light. In addition, one of the 8 digital inputs can be configured to be the external horn acknowledgment.  The output ”Relay Door” can be used to ...

4. RS232 Front Interface 2. Display 5. Link / Active LED 3. Navigation buttons Back side: 1. Modem Interface RS232 5. Analogue Inputs 2. Keypad Interface (Emka 2100) 6. Alarm and Door Output 3. Ethernet Port 7. Output Relays 4. Digital Inputs 8. Power Connector (230VAC) 1 2 3 4 5 ...

delivered from the factory the RMC is configured to monitor one temperature and to generate an alarm on channel 1 if the temperature reaches the high limit value of 60 degrees Celsius. When power is connected the RMC backlight activates and the latest fir ...

1. Disconnect the power cord 2. Wait a few seconds 3. Press and hold navigation button “Left” 4. Reconnect the power cord 5. Release navigation button “Left” when “Factory setting” is shown on the display. 6. Press navigation button “Up” and hold for a few seconds, th ...

It is recommended to use the Internet Explorer as web browser. The upper part of the PC terminal displays the front of the RMC and shows the 8 Alarm channels as well as the RMC display. In the lower part, a list of the last 15 events is shown, the latest event being listed at the top. Events caused by an alarm are ...

with an electronic locking mechanism, the door can be controlled by a 4 to 8 digit code. The opening mechanism has an adjustable response time of 1 to 60 seconds. The function can also be activated by a virtual "open door" button on the PC screen. Alarm reset: When an ...