Monte Carlo Fan Company Drawing Room 5ED56 D-L Series Owner's Manual And Installation Manual

Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: MODEL NUMBER: RETAILER NAME: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 5ED56XXD-L Series Fan Total fan weight with light kit UL Model No. : AC-556LF5800OD 12.38kgs 27.24 lbs ...

6/1/2012 2 WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use t ...

6/1/2012 3 Place canopy and then yoke cover over downrod as shown. Then thread the lead wires and safe - ty cable from fan through the downrod as shown. Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the serv ...

6/1/2012 4 Carefully lift fan assembly onto mounting br ack- et. Rotate fan so that the notch on the ball engages the ridge in the mounting br acket. This will allow hands-free wiring. 10 Attach blade assembly to motor using the motor screws and w ashers provided. Tighten screws securely. 17 Remove 1 screw and loosen 2 screws. ...

6/1/2012 5 Install switch plate by placing over the 2 screws and twisting into place. Install screw removed and tighten all 3 screws securely. 20 Push plug from fan and plug from switch plate together.Match the color strips on the plugs. 21 Put plug from fan through hole in switch plate. 19 Install glass and finial nut. 26 Plu ...

6/1/2012 6 1.Check main and branch circuit fuses or circuit break ers. 2.Check line wire connections to fan and switch wire connections in switch housing. 3.Make sure that any shipping stabilizer has been removed from motor. CAUTION: Make sure main power is turned off. 1.Check to make sure all screws in motor housing are snug ...