NTI ENVIROMUX Series Instruction Manual

Manual MAN215 Rev Date 7/26/2021 ENVIROMUX® Series E-STHS-LCDW Temperature/Humidity Sensor w/LCD Display E-PLSD Programmable LED Sensor Display E-STHSB Temperature/Humidity Sensor E-STSM-E7, STHSM-E7 Temperature/Humidity Sensors E-STHS-LSH Low Self-Heating Temperature/Humidity Sensor ...

i TABLE OF CONTENTS Introduction......................................................................................................................................................................1 Mounting................................................................................................... ...

1 INTRODUCTION Many different sensors can be connected to the ENVIROMUX Series Enterprise Environment Monitoring Systems. Series models covered by this manual include ENVIROMUX-SEMS-16U and E-16D/5D/2D. A complete listing of available sensors and accessories can be found at http://www.networktechinc.com ...

2 E-STHS-LCDW The E-STHS-LCDW is a Temperature and Humidity sensor built into a large wall-mount LCD display with 2” character height for easy viewing from a distance. There are two key-hole slots on the back, 4-1/2” apart, for hanging the sensor on the wall. A template has been provided to make ...

Template for easy mounting the E-STHS-LCDW Mounting Instruction Using Side Brackets 1. Mount one side bracket to each side of the sensor with the screws provided. 2. Position sensor and mark top of keyholes. 3. Drill two 3/16” diameter holes where top of keyholes were marked. 4. Insert wall anchors (pro ...

4 CONNECT SENSORS RJ45 Sensors The temperature and humidity sensors for the E-16D/5D/2D and E-SEMS-16(U) Enterprise Environment Monitoring Systems have RJ45 connection ports. Connect each sensor to one of the female connectors labeled "RJ45 Sensors" on the ENVIROMUX using CAT5 cable. The male RJ45 connec ...

5 E-xD firmware version 2.31 or later is required to support this sensor. E-STHS-LCDW The E-STHS-LCDW is a temperature/humidity sensor with built-in LCD display that has 2” tall characters for easy viewing from greater distances. . It has a temperature range of -4 to 140°F (-20 to 60°C) ±0.7°F (± ...

If longer than 150 foot cable is used, the MODE button will not function when the backlighting is ON Note: The CATx cable from the E-STHS-LCDW to the E-xD cannot exceed 150ft. Figure 6- CATx cable connection The cable from the ENVIROMUX will at ...

7 Figure 7- Select which sensor to display in LCD ...

8 E-PLSD The E-PLSD is a programmable LED Sensor Display with 2" tall status display characters to show the sensor value and 0.68" characters to indicate which sensor data is being displayed and the unit of measure. It includes three touch-sensitive buttons.  "Brightness" to control the LED display il ...