Jepson 9435 T3 Operation Instructions Manual

Chcmges for tec/111ical advancement reserved. 1 Premium Super Dry Cutter 9435 T3 (600560UST3) FOR YOUR SAFETY Read the manual Wear protective goggles Wear ear protector Wear protective gloves Operation Instructions ENGLISH FRAN <:;AIS ...

Certificate no. 1 A .. ® TUVRheinland License Holder: JEPSON Power GmbH Ernst-Abbe-Str. 5 52249 Eschweiler Germany Testreportno.: USA- 50296051 001 ClientReference: Mrs. Nikola Nestler Testedto: CSA C22.2 NO. 71.2-10 + Gil Certified Product: 14" Premium Super Dry Cutter Model Designation: 9435 Rating: Rated Speed: AC 115V, ...

2. Technical Specifications 3. Performance Data 4. Safety Regulations 5. Start-up 6. Operation 6.1 Adjusting the tensioning device 7. Standard Equipment 8. Correct Cutting Procedure at 90° 9. Recommendations 10. Warranty 8 8 8 8 6.1.1 Positioning of th ...

The construction saw PREMIUM SUPER DRY CUTTER is designed and built according to current international standards of the machine tool industry. The machines comply with the current regulations for emissions and safety at work, in particular the rules for the prevention of accidents. IMPORTANT If changes are made to a machine without our ...

1. The safety device may not be removed during the working process and must always be kept operational. 2. The adjustment keys and wrenches must be removed before the machine is turned on. 3. The workspace is to be kept tidy since an untidy working environment is the cause of accidents. 4. The machine should not be used in a dangerous ...

for the Premium Super Dry Cutter 1. Always clamp the work piece securely. 2. Observe the rotation direction of the saw blade. 3. Ensure that the saw blade is always sharp, is unimpeded and runs without vibration. 4. Lift the circular cold saw off the work piece before the safety switch is operated. 5. Before sawing, allow the ...

It is important for the safe operation of the circular cold saw as well as for good cut and a long life of the machine that the work piece is clamped securely. 6.1.1 Positioning of the rear chuck jaw base (Fig.1) The rear chuck jaw base can set to 3 positions (3 break points) to adjust it to different mater ...

The blade can be replaced easily by following these instructions: Step 1 Pull the power supply plug from the socket. Next, put the plug aside so that it cannot be plugged in accidentally. Step 2 (Fig. 5) Loosen the butterfly screw (A), turn the small cover (B) to the rear, pull up the vibration da ...

Regularly spray the spots where the saw blade comes into contact with the saw blade guides with lubricating oil spray. Since the vibration dampers are consumption parts, they should be replaced when they are worn down by approx. 3 mm to a residual value of 1 mm. MAINTENANCE: Replacing the carbon brushes: (Figure 8 and 9) 1. Replace the ...