ancnoble GG-005 Setup & Installation

Set maximum watering duration to prevent flooding by a fault, such as a broken hose to avoid wasting water. 1) Push [menu] key to browse into “Max” time limit set. 2) Digits for hour are flashing, push [▲▼] to adjust the hour. Then push [menu] key into minute set. 3) Push [▲▼] to adjust the min ...

ancnoble GG-005 until there is a beep, (Two beeps means successful learning, one beep means fail.) The valve will close; this wet level will be remembered as turn off point. One key to setup Dry/Wet Control Level ...

ancnoble GG-005 Set irrigation window then irrigation will only happen in this time window. 1) Push [menu] key browse into "start" and the digits will flash. 2) Push [▲▼] to adjust start hour and then push [menu] key browse into start minute setting. 3) After finished, push [menu] key to save. 4) Finish time and start time a ...

ancnoble GG-005 2) Push [▲▼] adjust hour to 23 hours, then push [Menu] into minute and adjust minute to 00, push [Menu]key to save. Interval Under Timer mode, setup timer Interval time ...

ancnoble GG-005 Note: The connector is waterproof，Please align the convex & concave before inserting and tightening. Connect moisture sensor Connect solar panel ...

ancnoble GG-005 1) When the soil is just dry to the point of needs irrigation, push and hold [Dry Ctrl] key until there is a beep, (Two beeps means successful learning. One beep means fail). Then the valve will open and start watering. This dry moisture level will be remembered as start irrigation threshold. ...

ancnoble GG-005 For example, If you want to start watering 06:00 every morning for 1 hour, should set up Start time as 06:00, Interval is 23 hours and duration is 1 hour. please prefer the following: 1) Push [menu] key browse into “start”, digits would flash which means up/down digits to setup. 2) Push [▲▼] to adjust to 06 ...

Push and hold [Menu/Mode] key to switch to operating mode one by one ...

ancnoble GG-005 standard of NH-11.5, user can screw to faucet directly. 2. Before installation, prepare some water outlet connector, pipes, drippers, etc. if needed. ...

1. Bury the sensor according to crop root system. If root system is shallow and small, such as vegetables, insert into the ground as shown, if root system is large and deep such as tree, bury deep to the soil. 2. If using the sensor as a rain sensor, bury the sensor where is no irrigation water can reach. ...