Crest Audio N-CODER Manual 

Module settings can be programmed ahead of time without the N-Coder connected to a module. Saved settings can then be downloaded to the module at a later time. Turn on the unconnected N-Coder, which will display: N-Coder will then prompt for module selection: Note that once a module is selected, it cannot be unselecte ...

100 Eisenhower Dr., Paramus NJ 07652 USA TEL: 201.909.8700 FAX: 201.909.8744 http://www.crestaudio.com Printed in USA v. 1.0 11/17/97 Crest Audio reserves the right to make improve- ments in manufacturing or design which may affect specifications. Crest Audio specification literature is available in downloadable PDF file format; visit ou ...

Crest Audio N-CODER The “Store to Memory” menu command permits the storage of up to 32 module parame- ter settings within the N-Coder. Settings may be read from a module and then stored in the N-Coder for ‘porting’ to other modules, or settings can be configured right in the N- Coder for downloading to modules later. Settings are sto ...

Crest Audio N-CODER The N-Coder is connected to Input Processing Modules using an RJ-14 cord (supplied). One end of the cord plugs into the N-Coder’s RJ-14 port (located on the top of the N- Coder), and the other end plugs into the Input Processing Module’s Data Port. (See dia- gram below). NOTE: the supplied RJ-14 cord ...

Crest Audio N-CODER To scroll through the adjustable parameters, use the ‘Up’ [d] and ‘Down’ [f] MENU keys. Parameter titles will be shown on the top line, with the parameter values displayed on the second line. (Parameter values that are currently in effect are always bracketed by asteris ...

Crest Audio N-CODER Power Processing Control About the N-Coder The hand-held N-Coder is used to configure all Input Processing “NC-” Modules except for DSP modules. The N-Coder allows you to change parameters affecting the amplifer's level, eq settings, crossover point, etc. Once set, the parameters are stored in non-volatile memory so that the amp w ...

Crest Audio N-CODER N-Coder SPECIFICATIONS Display: 2 x 16 character LCD window Connectors: RJ-14 jack connection to NC module (cable supplied) Power Source: 12VDC external power input (supplied), or 9VDC battery Controls: On/Off switch and panel buttons (MENU, VALUE, ENTER) ...

Crest Audio N-CODER for Download to Input Processing Module Stored settings residing in the N-Coder can be easily downloaded to Input Processing Modules. Connect the N-Coder to the Input Processing Module using the supplied RJ-14 cable. Once turned on, the N-Coder will display: N-Coder will automatically identify the connected module, read its ...