Solahart AtmosAir 180 Operation & Installation Manual

New South Wales 2116 Australia Telephone International Sales: + 61 2 9684 9100 Facsimile International Sales: + 61 2 9684 9180 Email: [email protected] Web: www.solahart.com ...

Solahart AtmosAir 180 Time ON 1 Press and hold for 2s. OFF 1 Press " " and hold for 2s to enter into the next setting without confirm the previous one. ON 2 Press " " and hold for 2s to enter into the next setting without confirm the previous one. Press " " and hold for 2s to enter into ...

Solahart AtmosAir 180 it goes through the compressor. On the discharge side of the compressor, the now hot and highly pressurized vapor is cooled d ...

Solahart AtmosAir 180 If the unit stops and you re start the unit or turn it on by the manual switch, the unit will not start to run again for approx 3 minutes. This is a protection feature to safe guard the compressor. In low ambient conditions the heating output decreases. Heating capacity Working conditions Defrosting In the heating ...

In the standby or running interface, press " " or " " once to check the target temperature of the outlet water. Press " " or " " again to change the target temperature. After making the changes to the parameter, press " " to confirm or " " to cancel the changes, then r ...

Solahart AtmosAir 180 Circuit breaker required The unit CANNOT be installed near flammable gas. Ensure that the base you are fixing to is level and strong enough. This unit requires a circuit breaker. failure to do so could result in an electrical shock or fire. OPERATION WARNING Prohibited Shut off the power Do not ...

16.5 1944.5 1277 Cold water inlet Hot water outlet Condensation water outlet Magnesium Over heating protector Electric heater Drainpipe 99 1177 1464.5 Pressure release valve 540 ...

Solahart AtmosAir 180 7.3 of the Pressure release valve Use Pressure release valve is used to pressure going too high inside the tank. When the pressure reaches the set value, the valve will open automatically so as to decrease the pressure . The handle of the safety valve should be pulled once every six months so as to remove th ...

Solahart AtmosAir 180 4.5 Trial running This unit requires an isolating switch as required by local by laws. 4.5.1 Inspection before trial running Check the water supply to the tank and pipe connections for possible leaks. Check that all power connections are secure before switching on. 4.5.2 Trial running Switch on the unit using the cont ...

Solahart AtmosAir 180 Check the water supply and air vent frequently, to avoid lack of water or air in the water loop. Clean the water filter Lack of water and dirty water can damage the unit. The heat pump will start the water pump per when it is not running, to avoid freezing. periodically, helping the water to stay clean. every 72 hrs Keep the uni ...