Samoa NEXU Installation Manual

NexU INSTALLATION MANUAL 27 order of the probes changes depending on whether it is a fresh fluid tank (Stop probe/S3 will be at the bottom of the tank) or a waste fluid tank (Stop probe/S3 will be at the top of the tank). The volume of fluid inside the tank is displayed in real time above each tank, expressed in the units of the system (L ...

Samoa NEXU NexU INSTALLATION MANUAL 53 4.4.7 LOCAL PARAMETERS SETUP ON UTANK To gain access to the main menu, please insert the bypass key into the unit and switch from normal position ( ) to bypass position ( ). The main menu will appear on screen: WARNING When the unit is in bypass mode, both the general air supply and the pump control valves wil ...

Samoa NEXU NexU INSTALLATION MANUAL 3 7 MANAGER .............................................................................................. 78 7.1 HOME.................................................................................................... 79 7.2 DEVICES .................................................................................. ...

Samoa NEXU NexU INSTALLATION MANUAL 26 General air supply solenoid valve: This output is intended to control the general air supply into the workshop. A time schedule can be set into the U-Track software with the working periods during which the air supply must be available. Alternatively, this output can be controlled manually from the U-Track (with ...

Samoa NEXU NexU INSTALLATION MANUAL 43 4 SETTING PROCEDURE AND DEFINITION OF THE PARAMETERS 4.1 SETTING PROCEDURE When the whole system is connected the following steps have to be followed to start the system up: 1. Set the local parameters in each one of the installation components (UDat / UDat Power+, UValves, UCounts, UVision, etc.). These local p ...

NexU INSTALLATION MANUAL 52 Pressing the power button shows the start screen (Fig. 1) during a short time. In the bottom left screen it is shown the UVision firmware. Then the unit will try to link showing the connecting screen (Fig. 2). This screen will disappear after a brief moment If the unit has already been configured, but if it has ...