Mitsubishi Electric PKA-RP·HAL Installation Manual

the air-conditioner unit. INSTALLATIONSHANDBUCH Aus Sicherheitsgründen und zur richtigen Anwendung vor Installation der Klimaanlage die vorliegende Bedienungsanleitung und das Installationshandbuch ...

6. Electrical work ...................................................................................................8 7. Test run ............................................................................................................14 ...

3. Installing the indoor unit 3.1. Check the indoor unit accessories (Fig. 3-1) The indoor unit should be supplied with the following accessories. PART NUMBER ACCESSORY QUANTITY LOCATION OF SETTING 35, 50 1 Mount board 1 Fix at the back of the unit 2 Tapping screw 4 × 35 12 3 Felt tape 3 4 Band 3 5 Wireless remote controller 1 6 R ...

■ PKA-RP·HAL Fig. 3-6 B A C E D 3.2.3. Installing the wall mounting fixture ► Since the indoor unit weighs near 13 kg, selection of the mounting location requires thorough consideration. If the wall does not seem to be strong enough, reinforce it with boards or beams before installation. ► The mounting fixture must be s ...

Left and left rear piping (Fig. 3-8) 4. Drain hose replacement ➡ See 5. Drainage piping work Be sure to replace the drain hose and the drain cap for the left and rear left piping. Dripping may occur if you forget to install or fail to replace these parts. C Drain cap 1) Be careful that the drain hose is not raised, and that ...

A Flare cutting dimensions Copper pipe O.D. (mm) Flare dimensions øA dimensions (mm) ø6.35 8.7 - 9.1 ø12.7 16.2 - 16.6 øA     Fig. 4-1 Fig. 4-2 () ()       4.1. Connecting pipes (Fig. 4-1) • When commercially available copper pipes are used, wrap liquid and gas pipes with commercially available insulat ...

4.4.1. Storing in the piping space of the unit (Fig.4-4) 1. Wrap the supplied felt tape in the range of the refrigerant piping which will be housed within the piping space of the unit to prevent dripping. 2. Overlap the felt tape at one-half of the tape width. 3. Fasten the end portion of the wrapping w ...

6.1. Indoor unit ■ PKA-RP·HAL (Fig. 6-1) Connection can be made without removing the front panel. 1. Open the front grille, remove the screw (1 piece), and remove the electrical parts cover. * Electrical work can be conducted more effectively with the panel removed. When attaching the panel, check that the hooks K at five locations on ...

PKA-RP·HAL Indoor unit power supply – Indoor unit input capacity *1 Main power switch (Breaker) – Wiring Wire No. × size (mm2) Indoor unit power supply – Indoor unit earth 1 × Min. 1.5 Indoor unit-Outdoor unit *2 3 × 1.5 (Polar) Indoor unit-Outdoor unit earth *2 1 × Min. 1.5 Wired remote controller (option) Indoor unit *3 2 × ...

PKA-RP·HAL Indoor unit power supply ~/N (single), 50 Hz, 230 V Indoor unit input capacity *1 Main power switch (Breaker) 16 A Wiring Wire No. × size (mm2) Indoor unit power supply & earth 3 × Min. 1.5 Indoor unit earth 1 × Min. 1 ...