AR 175A400 Operating And Service Manual

AR 175A400 stages. The Inhibit Interlock is wired to the rear panel interlock connector pins 1 and 8. A closed circuit from interlock connector pin 1 to pin 8 is required for normal operation. Opening the Inhibi ...

Syntax: RESET Parameters: None Response Format: None (No query for this command) Example: To clear any faults, send the following command: RESET 2.4.6.4 Level Adjust This command sets the RF gain of the 175A400. Syntax: LEVEL:xy Parameters: Parameter(x): GAIN = RF Gain V ...

AR 175A400 WARNING It is the responsibility of the user of this equipment to provide electromagnetic shielding, filtering and isolation which is necessary for EMC compliance to Directive 2014/30/EU. The equipment must therefore be operated in a shielded area which provides a sufficient level of attenuation to meet the radiated ...

AR 175A400 ...

AR 175A400 Query to get the firmware revision of the piggyback SBB assembly. Syntax: *SBB? Parameters: None Query only (always requires a ? character) Response Format: SBB_SW_REVx Where: x = firmware revision Example: To get the firmware rev. of the piggyback SBB assembly, send the following command: ...

AR 175A400 3.1 INTRODUCTION The Model 175A400 RF amplifier consists of a .01-400 MHz RF amplifier assembly. The RF amplifier assembly consists of a Pre-Amplifier (Pre-Amp) and two final amplifier modules. The power supply section consists of an AC input filter, a circuit breaker, +5V, -15V, +24V and two +40V power supplies, an Operate/C ...

AR 175A400 AC Power and Circuit Breaker Power Toggle Switch Remote Communication On Off On Off LOCAL REMOTE Command Query √ X X √ √ √ √ √ √ √ √ √ √ √ √ √ X √ √ √ √ X √ X = No, √ = Yes 2.4.6.1 Power On/Off This command controls the pow ...