Amit RRAM-MCT/E2 Operation Manual

RRAM-MCT/E2 Unit complete – see chapter 10.1. 10.1. Completion Part Quantity Train audio exchange unit 1 Power supply connector WAGO 769-110 counterpart 1 UIC interface connector WAGO 769-108 counterpart 1 Operation manual 1 Routine testing protocol 1 Insulation testing protocol ...

Amit RRAM-MCT/E2 connectors are located on device rear cover. ACT X3 ACT X4 X3 X4 Obr. 6 - Location of Ethernet connectors and their respective LED indicators Connector type: M12, D-coding, socket Connector Pin Signal Meaning X3, X4 1 TX+ Positive line ...

Amit RRAM-MCT/E2 D 7,0 mm 2,5 mm Obr. 20 - Detail of hole for screw in unit’s panel 9.2. Installation rules PE terminal of power supply connector must be connected with local installation earthing terminal. Minimum cross-section of supplying conductors must be at least 0.5 mm2. Communication line wires must be shielde ...

Factory setting can be restored through RESTORE button. To press the button use a tool with diameter max. 1.5 mm (e.g. match, or ballpoint refill). To restore the factory setting press and hold the RESTORE button while unit start-up. The PON LED first lights ON and after about 5 sec starts to blink. ...

Amit RRAM-MCT/E2 2 1 3 4 Obr. 2 - Design of RRAM-MCTE/E2 front panel ...

Amit RRAM-MCT/E2 publication and reserves the right to change the documentation without obligation to inform anybody or authority about it. This document can be copied and redistributed under following conditions: 1. The whole text (all pages) must be copied ...

Amit RRAM-MCT/E2 built-in power audio amplifier, two Ethernet interfaces and single M12 interface.  1 × UIC interface  1 × RS485 interface  1 × audio input  2 × Ethernet interface  2 × power audio output  Power supply voltage ...