Amit RRAS-MCT/D20 Operation Manual

conformity assessment has been performed in accordance with harmonized standard ČSN EN 50121-3-2 ed. 4. Tested in accordance with standard Type of test Classification EN 55016-2-1:2014 Specification for radio disturbance a ...

Amit RRAS-MCT/D20 2.2 Recommended drawing symbol Following drawing symbol is recommended for RRAS-MCT/D20. Only part of it will be visible in following examples. RRAS-MCT/D20 PWR X2 SP+ SP- Vcc GND PE 3 4 5 1 2 7 8 6 AD2 AD1 COM X1 ETH RJ45 X3 ...

Amit RRAS-MCT/D20 LED indicators are located next to Ethernet connector. Ethernet connector Fig. 13 – Location of Ethernet line connector Activity of Ethernet line is indicated by LEDs (LNK and ACT) next to Ethernet connector. The SPD LED indic ...

The microphone is connected to IP audio digitizer through D-sub DE-9 connector. Microphone itself is not supplied together with audio digitizer, it must be ordered separately. RRAS-GNM/A microphone connector Fig. 7 – Location of connector for microphone Terminal Signal Signal type on RRAS-M ...

Amit RRAS-MCT/D20 this input depends on used application. Sound input connector Fig. 12 – Location of connector for sound signal The sound signal is connected through standard BNC connector. ...

Amit RRAS-MCT/D20 512 KB Internal RAM 128 KB EEPROM 2 KB Type External, RRAS-GNM/A Microphone powering Phantom 3.3 V DC, software controlled Signal amplitude Max. 1 V pp. Input impedance Powering ON: 1.8 kΩ Powering OFF: 10 kΩ Connection point Connector D-sub DE-9 plug Re ...

Amit RRAS-MCT/D20 Time after time, with regard to way of using it is necessary to remove dust from device. The equipment can be cleaned by dry soft brush or vacuum cleaner, only when turned-off and disassembled. The maintenance mentioned above can be performed by manufa ...