Sun Microsystems Dual Release Notes

3 Known Issues This section describes the known issues and workarounds at the time of this release. Very Heavy Traffic Between Solaris 10 8/07 and Red Hat Enterprise Linux (RHEL 4.6) Clients (CR 6685402) With heavy traffic from Sun Blade X6250 Server Modules with RHEL4.6 (64-bit) to Sun Blade X6250 Server ...

Sun Microsystems Dual Removing a nxge VLAN With the vconfig Command Causes System to Hang on Linux Platforms (CR 6509980) There are three possible workarounds: 1. If the main interface is not active and if no other VLANs or trunking is configured, do not do anything. After some time, the tx reclaim will activ ...

Sun Microsystems Dual 7 Replacing a 10GbE Multi-Fabric NEM If an Multi-Fabric NEM fails, you will need to replace it. Caution – The NEM should be replaced immediately after it fails. The Multi-Fabric NEM is a Customer Replaceable Unit (CRU). You replace the entire module. There are no subcomponents that you can replace. You c ...

5 nxge Driver Fails to Attach If 10GbE NEM PHY is Not Present If the nxge driver is loaded on the Sun Blade X6250 Server Module with the Sun Blade 6000 10GbE Multi-fabric Network Express Module (10GbE NEM) missing from either port, that port fails to attach. The driver should attach, but the link should be ...

Sun Microsystems Dual 1 Hardware and Software Requirements 1 Sun Dual 10GbE Fabric Expansion Module Support on Sun Blade X6250 Server Module 2 Check Hardware Release Before Installing CPLD Update 2 Required Patches 2 Known Issues 3 Very Heavy Traffic Between Solaris 10 8/07 and Red Hat Enterprise Linux (RHEL 4.6) C ...

Sun Microsystems Dual Sun Microsystems, Inc. has intellectual property rights relating to technology that is described in this document. In particular, and without limitation, these intellectual property rights may include one or more of the U.S. patents listed a ...

Sun Microsystems Dual 8. Press together and hold the ejector buttons on both the right and left ejector levers. 9. Open the ejector levers by extending them outward until they stop. 10. Hold the opened ejector levers and pull the NEM out. 11. Insert the new Multi-Fabric NEM into the chassis. 12. Reconnect all ...

Sun Microsystems Dual Module Release Notes These release notes contain late breaking information for the Sun Dual 10GbE Fabric Expansion Module. Hardware and Software Requirements Before installing the FEM, ensure that your system meets the hardware and software requirements listed in the following table: TABLE 1 Hardware and Software Requirement ...

Sun Microsystems Dual Sun Dual 10GbE Fabric Expansion Module Support on Sun Blade X6250 Server Module The Sun Dual 10GbE Fabric Expansion Module (FEM) is supported only on the Sun Blade X6250 server motherboard with part number 375-3501-06 or newer. The Sun Dual 10 GbE FEM also requires CPLD version 231. To f ...

Sun Microsystems Dual After unzipping this file, go to Windows directory, which contains the documents and driver: Note – Multiple VLANs are not currently supported with the Windows OS driver. Hot-Swapping a Sun Blade 6000 10GbE Multi- Fabric NEM With Windows OS Driver Installed This section explains how to ...

Sun Microsystems Dual Sun™ Dual 10GbE Fabric Expansion Module Release Notes Part No. 820-4449-12 January 2009, Revision A Sun Microsystems, Inc. www.sun.com ...