Xerox Phaser 360 Operation & User’s Manual

not be reproduced in any form without permission of Tektronix, Inc. Tektronix ® , Phaser ® , PhaserShare ® , the TekColor logo, ColorStix ® , ColorCoat ® , and Made For Each Other ® are registered trademarks of Tek ...

iii Contents PhaserShare Networking Supplementary Information 1 Token Ring 2 Token Ring card 2 Token Ring connections and indicators 3 Ring speed jumper 4 Setting Frame Routing from the front panel (Phaser 750) 5 Token Ring parameters 6 Setting Token Ring parameters 7 Setting IP addressing: Po ...

Contents Resetting the Printer 41 Resetting the printer: PhaserLink Printer Management Software 41 Resetting the printer using the Apple Printer Utility 41 FTP Interface 42 Usage Profile Report fields 43 Job Report fields 43 Full Report fields 44 Logs 51 Index 56 ...

1 PhaserShare Networking Supplementary Information PhaserShare Networking Supplementary Information This manual contains supplementary information to your printer’s networking setup guide. The following is an overview of the contents: I Token Ring on page 2. Complete information on the PhaserShare Token ring card, including ...

Token Ring Token Ring Token Ring card The printer can be connected to a Token Ring network using an optional Tektronix PhaserShare Token Ring Card. The PhaserShare Token Ring port conforms to the IEEE 802.5 standard. With the PhaserShare Token Ring card, you can connect the printer directly to a Token Ring network using shiel ...

3 Token Ring Token Ring connections and indicators The PhaserShare Token Ring card has the following connections and indicators on the rear panel: 1. Shielded Twisted Pair (STP; IBM Type 1) connector (DB-9). 2. Unshielded Twisted Pair (UTP; IBM Type 3) connector (RJ-45). 3. Ring speed indicator (yellow); on indicates 16 Mbps, o ...

Token Ring Ring speed jumper The Token Ring card is equipped with a single three-pin jumper to set the ring speed. There are two settings: 4 Mbps and 16 Mbps. Note If you received your printer with the Token Ring card already installed, you must turn off the printer and remove the card before you change the jumper setting. The ...

5 Token Ring Setting Frame Routing from the front panel (Phaser 750) You can set the Token Ring Frame Routing from the printer’s front panel. When you have the Frame Routing set, you may want to set other Token Ring parameters. See Setting Token Ring parameters on page 7. See the table Token Ring parameters on page 6 for ...