Solahart ATMOS AIR 270 Operation & Installation Manual

Press " " and hold for 2s to enter into the timer setting interface. The symbol "ON " and the date parameter are flashing at this time. Then set the date in the same way as "2.4 ". Example: Set the start-up date on September 28.(Note: ) Turn off the unit before going out. Vacation mode Outlet water ...

Solahart ATMOS AIR 270 Before installation, please ensure that you leave the space as shown below for maintenance. Air outlet Display Barrier 500 1000 300 Unit:mm 10 600 500 ...

Solahart ATMOS AIR 270 Press " " and hold for 5s once to lock the keyboard. Press " " and hold for 5s again to unlock the keyboard. Press" " and hold for 5s Lock icon ...

Solahart ATMOS AIR 270 640 16.5 B A C P&T valve Over heating protector Electric heater Drainpipe 98.5 D E Cold water inlet Hot water outlet Condensation water outlet Magnesium Model A(mm) B(mm) C(mm) D(mm) E(mm) ATMOS AIR 270 1955 1425 577 1195 1095 ...

Solahart ATMOS AIR 270 system under the house eave or in a sheltered environment may help prolong the life of the system. ...

Solahart ATMOS AIR 270 Cut out the water supply connection between the tap water supply and the tank by closing the corresponding valve. Open the hot water outlet and then open the drain outlet valve at the same time. The water in the tank will be drained out through the drain outlet. loosen the screws and open the cover Press the red butto ...

7.3 use of the P&T valve is used to prevent the temperature or pressure going too high inside the tank. When the temperature or pressure reaches the set value, the valve will open automatically so as to force the pressure or decrease the temperature. The handle of the safety valve should be pulled once every six ...

Solahart ATMOS AIR 270 Outlet water temperature Current time Press " " and hold for 2s. ON 1 OFF 1 Press " " to confirm Successful setting Press " " to cancel the setting and exit. Without saving Confirm the time after setting. Confirm the time after setting. ON 2 OFF 2 Confirm th ...

Solahart ATMOS AIR 270 Time Target temperature Press or again to change the target temperature. Press to confirm or to cancel, then return to the previous interface. Press once or to check the target temperature. 5.2.4 Time setting In the standby or running interface, do as follows to set the time when in heating mo ...

26 6.2 The normal failure and solutions For any malfunctions, please refer to the table below : P01 Top tank water temp. Failure P02 Coil temp. Failure P04 P05 P07 E01 E02 E03 E04 E07 E08 E09 Ambient temp. Failure Refrigerant absorb temp. Failure High pressure protection Low pressure protection Water flow failure Electric-heater ov ...

Solahart ATMOS AIR 270 4.5 Trial running This unit requires an isolating switch as required by local by laws. 4.5.1 Inspection before trial running Check the water supply to the tank and pipe connections for possible leaks. Check that all power connections are secure before switching on. 4.5.2 Trial running Switch on the unit using the cont ...