PureLink FX1010 Instruction Manual

CHAPTER PAGE Important safety instructions ������������������������������������������������������������������������������������������������ ...

Read the operating instructions carefully and especially observe the safety information before using the device� If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property� Such cases will invalidate the ...

1080p / WUXGA signals� Using Multi-Mode Fiber technology, the DVI signals incl� HDCP encryption are transmitted over only one Multi-Mode 50/125 fiber core. Sources and display devices both feature galvanic isolation to avoid ground lo ...

24 pole DVI-D plug Fiber: LC simplex DC Power: Micro-B USB Data rate: 6�75 Gbps (2�25 Gbps per color) Resolution: WUXGA (1920x1200) / 60Hz Video Delay: 0 frames HDCP pass through: Yes EDID emulation: Transparent EDID LED indicators: Link & Power Status LED‘s RS-232 pass through: No Fiber: OM1(62�5/125), OM2( ...

TX Extender: Connect to the DVI output of a source RX Extender: Connect to the DVI input of a monitor 2. Mounting Screw: TX Extender: Secure to/remove from the DVI mounting hole of a source RX Extender: Secure to/remove from the DVI mounting hole of a monitor 1. LC Connector (Female): TX Extender ...

2. LED Status Indicator - Link 3. DVI Connector (Male) TX Extender: Connect to the DVI output of a source RX Extender: Connect to the DVI input of a monitor 4. Mounting Screw TX Extender: Secure to/remove from the DVI mounting hole of a source RX Extender: Secure to/remove from the DVI mounting hole of a ...

The blue LED will appear on the transmitter and receiver after all the product connections are completed� Red LED On: Power supply� Blue LED On: Signal Transfer� Red Led On and Blue LED Blinking: Only power supply, no signal recognized� 9. INSTALLATION DIAGRAM CAUTION: DO NOT connect power to the device until all other conne ...

the product. Maintenance, modifications and repairs are to be performed exclusively by an expert or at a qualified shop. If you have questions which remain unanswered by these operating instructions, contact our technical support service or ot ...