Tonghui Electronics TH7105 Operation Manual

keys, you can cancel it by pressing the  key or ESC key.  SD Volt 1) Description This parameter indicates the operating voltage of surge/drop, which ranges from 0.0 to 300V. When the parameter value is greater than the set voltage, it is a surge; when i ...

50 M1-1M1-1M1-2M1-3M1-3M1-4M1-4M1-5M1-5M1-5M1-6M1-7M1-7M1-7 M1-8M1-9M1-9 M1-1M1-1M1-2M1-3M1-3M1-4M1-4M1-5M1-5M1-5M1-6M1-7M1-7M1-7 M1-8M1-9M1-9 M2-1M2-1M2-2M2-2M2-2M2-1M2-1M2-2M2-2M2-2M2-1M2-1M2-2M2-2 M2-2 M1-1M ...

Tonghui Electronics TH7105  OVP When the voltage output range is from 0V to 150V, and the output voltage exceeds the set voltage 5V, or when the voltage output range is from 0V to 300V, and the output voltage exceeds the set voltage 10V, the display will display “OVP”, alarm beep (when the beep is on), the ON/OFF button indic ...

Tonghui Electronics TH7105 Shorthand for command: :SYST:BEEP:FAIL OFF or :SYST:BEEP:FAIL 0 Command description: This command is used to turn off the fail beep. Command Syntax: :SYSTem:BEEP:FAIL? Shorthand for command: :SYST:BEEP:FAIL? Command description: This command is used to query the status of the FAIL beep.  Comm ...

Tonghui Electronics TH7105 ————————————————————————————————————————————— Note: The serial port pin definition of this tester is basically the same as the pin definition of the standard 9-core RS232C connector. To avoid electrical shock, turn off the power before ...

Tonghui Electronics TH7105 1) Command Description This command is used to obtain the output voltage. The command is valid when the output is turned on. 2) Send Instruction Format 3) Return Instruction Format Return instruction data range is 0.0~300.0V 6.4.3.64 Address 65 (Output Current) 1) Command Description This command is used to obtain t ...

Tonghui Electronics TH7105 3.1.2.1 Soft key Instruction and Operation  PARA DISP 1） Description This soft key is used to switch display of output parameters. When pressed, all output parameters are displayed. 2） Operation Under page, press the PARA DISP soft key to switch the display of output parameters.  AUTO 1) Desc ...