RedMax CA-EX230 Operator's Manual

10-18 FR-CA Manuel d’utilisation 19-27 ...

Contents Introduction.....................................................................2 Safety..............................................................................3 Operation........................................................................7 Maintenance................................................................... 8 Transportation, st ...

The arrow indicates the direction of rotation. 50FT 15 m 50FT 15 m The operator of the attachment must ensure, while working, that no persons or animals come closer than 15 meters. Always wear approved protective gloves. Wear sturdy, non-slip boots. Keep all parts of your body away from the hot surfaces. Watch out ...

for. • Never use the Product if you are tired, if you have drunk alcohol, or if you are taking medication that could affect your vision, your judgement or your co- ordination. • Never use the Product in extreme weather conditions such as severe cold, very hot and/or humid climates. • Never use a ...

• Wear hearing protection that provides adequate noise reduction. WARNING: Listen out for warning signals or shouts when you are wearing hearing protection. Always remove your hearing protection as soon as the engine stops. WARNING: Long-term exposure to noise can result in permanent hearing impairment. So always u ...

attach, examine or clean the cutting equipment. • Use protective boots with steel toes and non-slip soles. • Use clothing made of a strong fabric. Always use heavy, long pants and long sleeves. Do not use loose clothing that can catch on twigs and branches. Do not wear jewelry, short pants, sandals or g ...

cracked. 2. Replace the guard if it has been exposed to impact or is cracked. Safety instructions for maintenance WARNING: Read the warning instructions that follow before you do maintenance. WARNING: Always stop the engine before you work on any part of the attachment. It can continue to move even after the t ...

instructions. If you need further information please contact your service workshop. To replace the blades 1. Loosen the split pin. 2. Remove the cutter package from the gear housing’s output axle. 3. Mount the cutter package onto the gear housing’s output shaft. Make sure the direction ...

3.7 Dimensions, mm 2x cutters 140 4x cutters (accessory) 235 Noise emissions1 Sound power level, measured dB (A) 107 Sound power level, guaranteed LWA dB (A) 110 Sound levels2 Equivalent sound pressure level at the operator’s ear, measured according to EN ISO ...

...