OVER COVER CORE 6-10 kVA Operation & User’s Manual

and it may not be reproduced without permission. We reserve the right to modify the design and specifications without prior notice. ©Copyright 2016 COMEX S.A. All rights reserved. ...

1. Safety rules....................................................................................................................................... 1 2. Transport, unpacking UPS ................................................................................................................ 3 2.1. Rack 19’’ Installation ... ...

This manual contains information on the safe use of the UPS. Before unpacking and installing the power supply, please read it carefully and follow its recommendations. Meets the standards - EXECUTION EN 62040-3 Uninterruptible power systems (UPS): The methods for determining the properties and test requirements. Meets the standards - Elect ...

which should be used during installation and maintenance of the UPS and batteries. • If the power supply is cold and will be moved to a warm room, condensation may occur. Therefore, you should wait at least 2 hours until its launch. • To reduc ...

Check carefully that the carton and the contents are not damaged. If any damage is found, immediately notify the shipping company and distributor of power supply. Do not dispose carton of UPS. 1. If there was not any damage carefully open the carton. 2. Extract all the protective elements (sponges, fillers). 3. Gent ...

3.1. Rear panel view Draw 1 UPS COVER CORE 6-10K Draw 2 Battery module COVER CORE 6-10K 1. Current Connector (version only parallel operation) 2. Connector for parallel operation (only for versions of parallel operation) 3. External battery connector 4. Slot for SNMP 5. RS-232 6. USB 7. Remote EPO 8. Circuit breaker 9. ...

Before connecting the battery module and the breaker UPS must be OFF. 3.2. Connection of external batteries Connect one end of the battery into the corresponding slot on the rear panel of the UPS, the other end of the slot located on the battery unit. In the case ...

UPS CORE 6K and 10K is designed for permanent connection via terminal which is localized on the rear side of UPS, as shown below. UPS suitable for installation in single-phase three-wire, TN with grounded neutral. The UPS must be connected to a separate electrical system, made in accordance with the applicabl ...

To enable automatic management and monitoring of the UPS, connect the supplied UPS USB cable from one side to the USB port on the UPS and the other into the USB port on your computer. Supplied with the UPS software allows you to automate processes on / off receiv ...