Electrolux E15IM60EPS Installation Manual

(37.9) 24” (61) 21 - 3/4” (55.2) 34 - 1/8” (86.7) FULL RETRACT HEIGHT WATER VALVE WATER OUTLET WATER DRAIN 5” (12.7) Figure 1 ...

unit. All ice makers require a connection to the water supply and improper hook-up can result in substantial property damage! All water and drain connections MUST BE made by a licensed/qualified plumbing contractor. Failure to fol ...

outlet. 2 Carefully push the power cord grommet through the hole in the back panel. See Figure 2. 3 Remove 12 screws and back panel. 4 Check that the clamps and hose connections are tight at the following areas illustrated in Figure 3: • Discharge tube (A) • Drain tube (B) • Vent tube (C) 5 Pl ...

CONNECTING A DRAIN PUMP If a gravity drain connection is not available, and you have not purchased the E15IM60E with factory installed pump, we strongly recommend the use of the Electrolux EIMP60 drain pump. The Electrolux EIMP60 drain pump is available through your Dealer, or direct from Electrolux with complete installation instruc ...

1 Position the unit on a flat, level surface, capable of supporting the entire weight of the unit. Remember that the unit will be significantly heavier once it is fully loaded. 2 The surrounding air temperature must be at least 50°F (10°C) but must not exceed 110°F (43°C). 3 The unit must not be located near heat-gener ...

6 Install and connect the water supply line. See Connecting the Water Supply for installation requirements. 7 Position the unit to allow free air flow through the front grille (see Figure 6). 8 Wipe out inside of unit with a damp cloth. NO NO NO NO NOTE TE TE TE TE The door of the unit may be mounted on either side of the cabinet (see REV ...

CONNECTING THE WATER SUPPLY When connecting the water supply, follow these guidelines: • Review the local plumbing codes before you install the unit. • The water pressure should be between 20 and 120 psi. • Make certain a SHUT-OFF VALVE is installed in the 1/4 inch water supply line. • Connect sufficient tubing to the unit to ...

recheck water and drain connection for leaks. Apply additional tightening if needed. Do NOT use thread sealing com-pound or tape. Water Supply Connection 1 Locate the compression fitting and ferrule packed in the unit. Slide the compression fitting and ferr ...

1 Use a level to check the levelness of the ice maker from front to back and from side to side (see Figure 11). 2 If the ice maker is not level, adjust the feet on the corners of the unit as necessary (see Figure 12). 3 Check the levelness after each adjustment and repeat the previous steps until the unit is level. IMPOR IMPOR IMPO ...

All Electrolux units may be left or right hand opening. The door opening is easily reversed by moving the hinge hard-ware to the opposite side (see Figure 13). To reverse the door: 1 Remove top hinge screw pin (7/64" Allen wrench) from cabinet (see Figure 14). Remove doo ...