Electrolux QUATTRO 52 PM Instruction Manual

Allekirjoittanut, E.O.P.I. in valtuttaamana, vakuuttaa että seuraavat tuotteet: 52 quattro T, ja jotka on valmistanut E.O.P.I., Valmadrera, Italia, ovat Euroopan direktiivien 98/37/EEC (Koneisto-direktiivi), 93/68/CEE (CE Merkintä-direktiivi) & 89/336/CEE (Elektromagneettinen Yhteensopivuus-direktiivi) mukainen, direktiivi 20 ...

COR ...

Do not smoke while re- fuelling or while operat- ing the trimmer Do not use metal blades Wear safety clothing: Approved safety glasses or face shield Wear safety clothing: Approved ear defender Wear safety clothing: Approved safety helmet Wear safety clothing: Approved gloves Wear safety clothing: Approved safety footwear MAX. 0000 Min-1 If not u ...

B. Safety precautions Blade thrust Beware of projected objects Maximum safety distance Choke fully opened (hot start / run) Choke closed (cold start) 1) Make sure all operators study this manual carefully before using the trimmer; only use this machine for usage specifically mentioned in this manual. Never allow children to use the trimmer. 2) Wh ...

ATTACHED (see sections SAFETY USAGE and BLADES AND NYLON STRING HEAD ASSEM- BLY). Pay careful attention to safety recommenda- tions as you might put your life or somebody else’s in danger as a result of: a) possible con- tact with cutting or rotating parts. b) possibility of projection of various objects. WARNING: do not start engine if i ...

D. Fuel mix E. Safety guard assembly caused when the blade touches against wood or solid bodies, such thrust might then cause the operator to loose control of the machine itself. Never attempt to work with a damaged blade but replace it with a new one. THRUST: can occur when using any type of circu- lar blade within the risk area: therefore it i ...

SAFETY USAGE and SYMBOLS. STARTING A COLD ENGINE 1) Position the on/off switch to the I (ON) position, away from the «STOP» position. 2) Rotate the choke lever in the direction illustrated by the arrows. This engages the fast idle system. 3) Squeeze the primer bulb (C) several times until you see fuel begin t ...

L. Regular maintenance From time to time ensure all screws are tight. Replace damaged, worn, cracked or warped blades. Always make sure nylon string head or blade have been assembled correctly (see sec- tions NYLON STRING HEAD and BLADE ASSEMBLY) and blade fastener is tightened. 1) AIR FILTER CLEANING (at least every 25 working hours). A dust clo ...

N. Ecology M. Replacing nylon line 1) Loosen the locking nut on the base of the nylon head by turning it clockwise. 2) Remove the base cover assembly. Remove the empty spool from the housing and discard any remaining line. REWINDING NEW LINE 3) Prepare 2 lengths (8ft each) of 2.4 mm nylon line. Thread 1 end of each line into the two holes on oppo ...

Fault finding table DISPLACEMENT (cm 3) 52 ENGINE OUTPUT (Kw) (ISO 8893) 2 BORE AND STROKE (mm) 47x30 ENGINE SPEED AT MAX POWER (min-1) 7.500 MAXIMUM SPEED, NO LOAD (min-1) 10.000 MINIMUM SPEED (min-1) 2.800 BLADE SHAFT SPEED (min-1) 8.500 BLADE LOCKING NUT TIGHTENING TORQUE (Nm) 17 DRY WEIGHT (kg) 9,5 FUEL TANK CAPACITY (cm 3) 950 Coil/flywheel ...